wesintl

We have a fully serviced, fully-cleaned and machined late 2F cylinder head ready to go. The original PN would have been 11101-61040. Hard to find in good shape. Machining was done by Machine Works in Tucson, AZ. New OEM valves were installed...

@cruiseroutfit for the win! Thank you Bryce and gang for the parts, and great customer service as always. We’re lucky to have a company like this around! Pallet of Cruiser parts showed up… time for some reassembly. Bit the bullet and bought...

Knocked out new rear wheel bearings from Koyo and factory fresh seals.

Talked gaskets, sealants and not cross threading on reassembly. Everything is going smoothly so far. Had to clean up a few studs but it’s going well. Popped in a new Allen head drain plug with magnet. Should keep it away from rock damage...

I did this same swap into my 76 several years ago. In my case I left the transmission hump in and just removed the shifters. Used a 2 ton hoist and pulled the entire drive train, removed seized 2F, replaced clutch, throwout and attached new...

I have the same procomp 2.5" lift and blew out a shock which means I need new shackles, bushings and everything too.. 😉 😜 Will watch thread for insight.

We have a few sign up each year, then get cold feet and bail at the last moment. I had 4 signed up last year and all but one bailed. Then the last trooper decided she didn't want to be the only gal among all the dudes. I get it.

Zoom in on the PN and it’s clear on the kanban.

You can do it without extra gas, but will feel better if you have at least some. Fill up again in Hanksville... and if the Hite ranger station is open for gas you can go out that way instead of back up to the Ranger Station as it's shorter and...

KZ family is almost just as shïtty as the L family of engines. I have 4 KZ engine overhauls lined up for the summer. If you are in it to flip it, this is the wrong crowd.

That looks EXACTLY like the 1971 I had, including the color. The used car dealer said the green charging light on the dash wouldn’t go out even after he replaced the battery, alternator and VR so he made a deal on it $1,700. I paid him, took it...

We decided to take advantage of nice day and look over the parts right that we got got back in January. We tossed some jumpers on the battery, cleaned up the terminals and posts, looked for oil, checked the coolant (none visible) and poured some...

Attended the Cruiser Summit in Oceanside today. The weather report of rain kept some people at home. Their loss it was a good time, Pat the owner of Summit Steel had a wood fired pizza guy on hand making great pizzas to feed the masses. Pat...

We’ve got the big stuff all knocked out. The boys have been working hard. We have a few little projects to knock out and then we are into full reassembly. It’s amazing BOTH how much we can get done in a class and how little we can get done in...

Fuel line day: my BJ70 had 8mm fuel feed for the IP. 1PZ has 10mm fuel feed. Used some 3/8 line to make new ones. My friend Hubert —bike fabricator for a living—came down to help out. More pieces of the puzzle. I’ll get these...

Bump It Offroad is also giving away one of our brand-new 80-series battery tray replacements at the Cruise Moab raffle...

One lucky participant will win a Bump It Offroad fairlead at the raffle! These sure do look good on the front of a BIO bumper. Not available in stores...

That kid is old enough to drive now!

do you still make these?