Where is the Fuel Filter?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 6, 2006
Threads
88
Messages
402
Location
Cincinnati, OH
(NEVERMIND) Where is the Fuel Filter?

I think i found a thread, ignore this.

I'm doing some PM on my fj80, where is the fuel filter. better yet where is a writeup on how to change it, i can't find the write up anywhere.

I tried dling the service manual from their website, seems like i didn't get that part when i did the mass download.
 
Last edited:
I did mine....it is a PAIN the a&& getting to it.. You need two people to do it. It is not too far from the PHH. Honestly, it is hard to see it from looking down...and hard to find from looking up. This is not very helpful but once you get to it, it is quite simple. There is an "In" and "Out" nipple. Simply pull out and "plug" back in the new one.l
Good luck...it is tough to get to.
airlaird
 
Please post pics if possible of the location of the fuel filter. Am planning to replace mine in a couple of weeks and it surely would help to see where the fuel filter is located.
 
It's raining way to hard for a pic, plus I doubt I could get my cluncky ol' digi cam where it's at.

Look under side your intake manifold - should be dead center and a few inches off the block.

I'm sure the FSM has a way to do the job - I changed mine when I did a HG.

IIRC it's ~4" long, and ~2" diameter.

Seems like its' retainer bracket bolted to the intake manifold.
 
1 person can do the fuel filter, though 2 people makes it easy.

Make sure you take the wheel off, and pull those stupid wheel well flaps too.

you'll need a universal if you can get one, and make sure to purge the fuel line by taking off the gas cap.

You'll get a few drips so have a container ready and no smoking!
 
I just did mine yesterday. It was first time for me to replace the filter on 80 and it took me about 3 hours to do it and probably spent 2&1/2 hrs of it trying to find ways to get to it. Now I think next one will take about 30 -45minutes.
Good luck and enjoy it.
 
I just did mine yesterday. It was first time for me to replace the filter on 80 and it took me about 3 hours to do it and probably spent 2&1/2 hrs of it trying to find ways to get to it. Now I think next one will take about 30 -45minutes.
Good luck and enjoy it.

You should cut into it and see how nasty it really is!

A good investment to swap these out on a regular basis, regardless of the difficulty of pulling it.
 
Anybody got pics to share of where the fuel filter is? I don't have the FSM and this will be my first time to also change the fuel filter. I'm going to do this next weekend together with the oil change/filter change
 
It's under the intake manifold...yes, you read it correctly. Do a search with my name and fuel filter and some pics should pop up. Good luck!
 
Just for kicks...

Looking up from under the left front wheel well towards the intake plenum...

FZJ80_fuel_filter.JPG


I think you'll want to disconnect the fuel pump fuse and run yer engine 'til it dies to take down any pressure in the fuel lines before removing...
 
Podiev,

In your case it's right next to the Driver's side shock absorber and pretty much at the top. It's easy to access but a bit clumsy to move around as there's a bunch of stuff there.

Be sure to push the button on top a whole lot of times before trying to re-start your engine after making the change.


Kalawang
 
I just changed mine. It took a couple of hours of contortions. I ended up moving the PS reservoir and the oil dipstick. Make sure that you use new gaskets on the banjo fittings. You don't want to go in there again to fix a leak.

The easiest way to describe the location is to put your hand on the trans dipstick. Move your hand down 3 inches and then to the right side of the truck 6 inches. You should be under the middle of the lower intake plenum. Just about 2 inches past where your hand can't go any farther without pain is where it is located.
 
I see starter and frame rail...you sure it wouldn't be easier to go in from the wheel well with the tire off?
 
That's how I had access to it after spending about 2&1/2 hrs peeking from top and from under and some step #6 and repeated the whole process.
I'm sure if any of my neighbor had seen me for more than a few minutes would have found me very entertaining!
Then finally I just removed the mud flap and I was done in about 25 minutes.
 
Can anyone explain this a little better? Going to do the fuel filter replacement soon and I wanted as much ease as possible after all of the fun stories I have heard about replacing it.

What he means is catching the bolt closest to the motor can be a pita if you don't have the right tools, so by slotting the tab open, you can catch the bolt first (loosely), slide the filter in place, then tighten it :cool:



It's an easy job with the right tools though :)


Took me 20 minutes on a lift and the majority of that time was waiting for the fuel to drain completely....





Rick
 
Back
Top Bottom