where does the engine oil go?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 24, 2014
Threads
41
Messages
179
Location
Seattle, Washington
simple question, 1997 LC 1fzfe, almost 200k miles.

I recently replaces the valve cover gasket, spark plug tube seals, PCV valve and grommet and distributor O-ring,not a leak that I see. no puddles under the LC, so where is all of the oil going? could it be getting consumed thru the PCV valve hose? any Ideas?
 
Probably a combination of some of it going thru the valve guides and some of it going past the rings. Basically it is all burning up in the combustion chamber and going out in the exhaust.
 
See if it's floating on your Antifreeze.
 
A bit of oil use is not uncommon. All three 80's in our family use a bit. My 97 used quite a bit through the valve seals (around 230,000 miles) until i did a had gasket pm and put new seals in. That one was easy to see, basically a puff of blue out the exhaust if it idled for a couple minutes. I've done head gaskets on two of the three trucks and the cylinders look excellent, so really, oil use is just a way of life with these imo.
 
oil isn't boiling or steaming. I've seen this before in some ladie's Sami.
coolant is clean no oil sheen.

I don't think the rear main or forward main leaks. I started using full synthetic instead of blended. I don't see the mpg increase, or smoother running engine. may go back to blended oil.
 
A bit of oil use is not uncommon. All three 80's in our family use a bit. My 97 used quite a bit through the valve seals (around 230,000 miles) until i did a had gasket pm and put new seals in. That one was easy to see, basically a puff of blue out the exhaust if it idled for a couple minutes. I've done head gaskets on two of the three trucks and the cylinders look excellent, so really, oil use is just a way of life with these imo.
no blue smoke, or white.
 
RedJed78: How much oil is your (?which) engine using?

My 80's 1FZFE has not leaked a drop for the last six years, never leaked much at all before that, but over the past 200,000 miles the oil consumption has slowly and steadily increased, from one quart in 5000 miles (Mobil 1 5w-30), to one quart in 1200 miles (Mobil 1 10W-40). The only time I see smoke (rarely) is if I stomp on the accererator, intermittantly and not every time, maybe more likely with a cold engine.

Point is, the engine can burn a lot of oil slowly (past the valve seals/guides or rings) where you never notice any smoke out the tail pipe.
 
I had this problem as well. From what I understand is that the valve seals go bad faster than the engine. My fzj80 was drinking about a quart every 800 and more on a long trip. No issues, compression test was good, HG test was good, tune up, did everything until I realized that had to be it. That much oil being burned will mess up the cat converters among other things. This issue drove me nuts, so much that I couldn't deal with it anymore. The issue is you have to take the head off to fix this problem, so you might as well just overhaul once that happens. So you have to weigh the options of a quart every few months or a few thousand repaired.
 
200K if the head is on original valve stem seals, then I bet that.

I did new stem seals when I did my HG years ago & it took care of the useage, now I might lose 1/4qt between changes, and that I bank is my front main based on spotting.
 
you might not think it's smoking at all, but it can be hard to see....didn't think mine was until a friend was following me and noticed it
 
Valve seals, call Beno, find a guy or get the sst for the valve springs. What ever you do, don't remove the engine, transmission, and transfer case. No matter how bad ass it sounds, putting this 6'2" monster back into the truck IS the hard part. I had the same symptoms with oil consumption but with brass specs in my oil too. So both upper and lower refresh is in order for me.
 
I don't know about pertol land cruisers but I have replaced the valve stem seals in other cars without taking the head off by making an adapter out of an old spark plug and pressurising the cylinder with air, making sure the piston of the cylinder I'm working on is on TDC so if the valve drops it doesn't fall out.
 
When I see a puff of smoke out the tailpipe it usually is at night ie: when a vehicle is directly behind me, that is when I stomp on it to see if it is still smoking. I've increased the viscosity of oil I've been using to slow down consumption, even added some Bardahl smoke stopper snake oil, that did seem to help a bit. Trying multiple seal swelling additives (aimed at the valve stem seals) over the last few years did not help. Discussing this with a mechanic at ACC they mentioned they like to replace the valve stem guides when they are doing a head gasket, said they find that the guides are often worn which adds to the oil usage, on top of the bad valve stem seals. FWIW.
 
Burning some oil is common like others have said. Not sure what the Toyota spec is but with BMW's older than 2006 they allowed 1qt per 1000 miles on the standard engines and 1qt per 700 miles on the M performance engine cars.
 
Back
Top Bottom