What grease do you keep stocked?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 22, 2018
Threads
7
Messages
35
Location
Yuma, AZ
Hi all,

New to the FJ80. Been reading a lot of maintenance forums where different greases are used, but because everyone has their own preferences a lot of these jobs could probably use the same grease. With that said, what would I need stocked to do everything?

Steering zerks
U joints, slip yokes
Birfields
Wheel end bearings
Badlands winch re-grease
Brake guide pins

Missing anything?
Thanks
 
Valvoline Palladium
Lucas Red N Tacky 2



Other stuff:
White lithium
 
Valvoline Palladium
Lucas Red N Tacky 2



Other stuff:
White lithium

So basically get a quality moly and a quality tacky multipurpose grease? Then use the moly wherever it's specified and the multipurpose everywhere else?

And white lithium for anything exposed to dirt and dust?
 
This stuff is good...
download.webp
 
Valvoline ford/lincoln moly and valvoline red stuff
 
So basically get a quality moly and a quality tacky multipurpose grease? Then use the moly wherever it's specified and the multipurpose everywhere else?

And white lithium for anything exposed to dirt and dust?
I use moly in birfs/kunckles, drive shaft slip yokes.
U joints and wheel bearings get red n tacky 2.

Lithium is used on brake parts and interior sliding parts (doors, window regulator, latches)
 
Sil-Glyde works on: fitting hoses, brake pads, window runs, regulator channels, o-rings, etc....
 
Sil-Glyde works on: fitting hoses, brake pads, window runs, regulator channels, o-rings, etc....
Sil-Glyde is great stuff, I do have to say that on O rings i like Parker Super O Lube better.
lotimg53071.jpg
 
Hmmm... I've been putting moly in my U joints and drive shafts. Bad move?
 
Hmmm... I've been putting moly in my U joints and drive shafts. Bad move?
There is some discussion on not using moly in a roller bearing application because the moly causes the roller to slide, not roll.

The jury is still kind of out. Some guys use it everywhere, others only in the birfs......

Document your applications and miles. Maybe you can make a definitive answer.
 
There is some discussion on not using moly in a roller bearing application because the moly causes the roller to slide, not roll.

The jury is still kind of out. Some guys use it everywhere, others only in the birfs......

Document your applications and miles. Maybe you can make a definitive answer.
This is true in laboratory conditions. However, I very rarely service my truck in a class 1 cleanroom. I've been using the original Amsoil moly grease for over 15 years. 1 grease for all applications.
Over the last few years Amsoil changed their product line and they discontinued the GHD grease and replaced it with GPTR which I use for every application as well.
 
Back
Top Bottom