Steering wheel shaking

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 27, 2007
Threads
18
Messages
134
I have a 1991 landcruiser. Stock height, 35" tires. My steering wheel starts shaking 1-2" each way under certain conditions. It does this from about 35-45mph and when decelerating through that same range. If i am doing 70mph it is perfect, no wobble. under 40 or so , perfect also. If the steering wheel is maybe 5 degrees to the right , which is almost straight, no wobble at any speed, around turns it is worse. i jacked up each front wheel to check for play and there wasn't any. Any ideas?
 
Can slightly warped rotors cause this shaking, i have the same issue. My shaking got worse after my ABS light lit up and never turned off. Thats something i need to fix.
 
Can slightly warped rotors cause this shaking, i have the same issue. My shaking got worse after my ABS light lit up and never turned off. Thats something i need to fix.

Yes, but it should only present itself in that case while braking.
 
Hmmm, i guess i have to look at something else then that, i also get that shaking when on the highway or streets on a straight away but when taking any degree turn its smooth
 
Wheel Wobble

Check the wheel nuts, wheel bearings, trunion bearings, Tie rod ends, Track rod ends.
It will not be brake rotors unless the wobble occours under braking!!

Also have a steering shop check the wheel algnment with attention to the caster angle. The trailing arm bushes could be shot. Not enough caster = wobble.

Cheers
 
Also check the factory welds in the front steering linkage. I have a wobble randomly and found a nice cracked weld...also check everything else that has been suggested.
 
Front panahrd rod bolts might need a big spanner on the bolts and while your looking at it check the bushes for wear.

If you lay under your truck and look at both bush/mounting points while someone else pushes the front from left to right there should be no movement in the bus/bolt junction. If there is its either loose or the bushes are stuffed
 
Check the wheel nuts, wheel bearings, trunion bearings, Tie rod ends, Track rod ends.
It will not be brake rotors unless the wobble occours under braking!!

Also have a steering shop check the wheel algnment with attention to the caster angle. The trailing arm bushes could be shot. Not enough caster = wobble.

Cheers

Thanks for all the advice. I am a 1 or 2 banana at best , so i will get out my haynes manual to see what all that is lol. I am also going to make sure everything is torqued to spec. with 286,000 miles the steering stabilizer may be shot?
 
I had this too and checked everything. It turned out that the weeping drivers side knuckle had let grease collect on the inside of the wheel, and along with it...bits of grass, rock, gravel. When I had my tires rotated I told them to clean it out and rebalance that tire and it did wonders. Just a thought.
 
I am a 1 or 2 banana at best , so i will get out my haynes manual to see what all that is lol. I am also going to make sure everything is torqued to spec.

If you put your location in your profile, someone local to you might offer to help check out your steering and front suspension, or you could post in a club forum from your area. My bet would lean towards panhard or arm bushings, with wheel and trunion bearings a close second. Your steering stabilizer is most likely shot, but probably not causing the problem. Wouldn't hurt to take a look at it.

-Spike
 
Get your tires balanced.

I thought it was a whole mess of potential issues making my steering wheel dance. I took it to get balanced at a local tire shop and the steering wheel dance disappeared completely.
 
I second the tires balanced. It does wonders, believe me. If you've had them for a while, rotate them and balance them. It shouldn't be much money. I'm running very stock and have 33's with no wobbles and balanced tires.
 
Just a question, balancing mine fixed it like I mentioned, but will a shot panhard or bushing cause it to shake all the time? Just wondering because if it comes back and I clean it/balance it againa and it does not go away that would be a good place to start.
 
Wobbly Wheels

I had another thought about your problem.
Check the mounting points for the panhard rod and the welds where the panhard rod mount attaches to the chassis.

Our RHD ones have problems when fitted with large tyres and wheeled hard. The chassis rail cracks where the panhard mount is welded onto it and around the steering box mount points.
It is a bitch to fix but a good welder and a bit of prep work to gain access to the area usually reults in success.

Cheers
 
Back
Top Bottom