Sarmajor
Reactions
112

Latest activity Postings Media Albums About Badges Post areas

    • Sarmajor
      Sarmajor replied to the thread 80 series front Axel pushing out dust cap.
      There is no way that you could get 3/4 of an inch of birfield drive section sticking out of the drive flange unless the outer end of the birfield was sheared offf.
      • F5C77BED-1781-4F8D-8016-3D94A817A205.jpeg
    • Sarmajor
      Sarmajor replied to the thread Noob question about hub seal/knuckle rebuild.
      If you have the fully floating rear axle then the difference between the inner seals is a easy to tell as the rear inner axle seal is radically smaller than the front axle inner seal. Unfortunately i don’t have any experience with the semi...
    • Sarmajor
      Sarmajor replied to the thread 80 series front Axel pushing out dust cap.
      The drive section of the bir field is restrained from moving out by the brass bushing on the inboard end of the spindle. If the brass bushing / or bushing / bearing combo is not in place the drive section of the birfiled could move out but not...
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top Bottom