Hello again
see the video
see the video
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
I found this from Ford
hartbroscore.com
Hart Bros Rebuild - Water pumps | Rebuilding | Sales
Hart Bros Rebuild has over 50 years experience in rebuilding your water pump or smog pump. Discover a better way to drive.
hartbroscore.com
I don't remember if there were brushes on both sides of the vane, or not...
forum.ih8mud.com
Smog Pump Disassembly and Rebuild.
I recently found a place that does Smog Pump rebuilds for FJ40s and FJ60 - Click HERE - But I wanted to take apart my old Rebuilding Factory pump to see what they had done and to clean and replace what I could and use as a trail-spare (F'ing Kalif!!!) Now, @rusty_tlc had posted that the OEM...
forum.ih8mud.com
- Thread starter
- #4
I don't remember if there were brushes on both sides of the vane, or not...
Smog Pump Disassembly and Rebuild.
I recently found a place that does Smog Pump rebuilds for FJ40s and FJ60 - Click HERE - But I wanted to take apart my old Rebuilding Factory pump to see what they had done and to clean and replace what I could and use as a trail-spare (F'ing Kalif!!!) Now, @rusty_tlc had posted that the OEM...
- Thread starter
- #5
I will try brushes from FORD see how the will play
Do you really need the pump? Those brushes are kinda expensive, where you could just replace with an idler pulley and be done with the smog stuff, sell it off and get your money back.
Toyota Land Cruiser specialty parts
TLC Performance. A Toyota Land Cruiser specialist shop, service, repairs, restoration and parts sales for classic FJ40, FJ45, FJ55, and FJ60 Land Cruisers
tlcperformance.com
- Thread starter
- #7
I do have ide pulley kit in my possession, get my money back? what am I going to do with all the $ ?
Well, if you do desmog the truck, sell the smog parts here on MUD and get some money back...
- Thread starter
- #9
no, I like to keep it as God created with all bady parts
Ok. Let us know if those brushes work... Usually it's the vanes that break up, though.
Send it to B-Z Rebuilders in Canoga Park, California. They rebuild these for SOR. 818 703 0821 mention Mud and they will treat you right. 200 bucks and fast turn around. Check them out, they also rebuild P/S pumps.
- Thread starter
- #13
they did, not out the box, I have to file just the edge as they have one shart angle not too much, but look like it is working, how do you lubricate it ?
Just the bearings get lube, the brushes are graphite, so slippery.
- Thread starter
- #15
they are open bearings so I did pack lithium grease I do not think it will last