Sliders? Do it your self kit suggestions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 27, 2008
Threads
164
Messages
1,001
Location
Socal/ I.E.
I am thinking of getting a pre-cut and bent do it yourself kit. What are your suggestions? I have seen several companys that provide these kits. Do you have any exsperience with these? Let me know what you think.
 
Box Rocket is running the trail gear's for quite a while now i believe and likes them. There are varying opinions on welding to the frame; if it is a concern to you then you could fab up some sort of bolt on bracket looking at what others have done.
 
Box Rocket is running the trail gear's for quite a while now i believe and likes them. There are varying opinions on welding to the frame; if it is a concern to you then you could fab up some sort of bolt on bracket looking at what others have done.

Yep. I'm running the Trail-Gear ones but you can get the same thing from Marlin Crawler. Either one will work. Here's my original thread about mine....

https://forum.ih8mud.com/80-series-tech/137088-sliders-little-different-than-everyone-else.html
 
If you're going to the trouble of "fitting" a set to your vehicle, you might as well go from scratch and build exactly what you want. I doubt the do it yourself kits are 80 specific. The only thing I farmed out was the bends at the end of the outside rail; local guy, $50:)

Done-1.jpg

Complete build (see sig line)
 
Metal Tech was selling a DIY kit that included 80-specific laser cut frame mounting plates, U-Bolts, and hardware. You just add the mounting arms and slider rail. This would reduce a lot of hassle and still allow you to make custom sliders. I don't see this kit on the Metal Tech website, but it might be worth a call.

Here is the link on the vendor's marketplace.
https://forum.ih8mud.com/%2A%2A-ih8...-kit-rub-rail-kits-%24174-95-%24274-95-a.html
 
Back
Top Bottom