shackle reversal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 15, 2006
Threads
6
Messages
27
Location
Cascade, ID
I am taking on the shackle reversal this weekend. Two questions: 1. Which is better using the front shackle mount in back or drill the frame. 2. do I have to reverse the springs.
:confused:
 
1 depends on how much if any lift you want.
2 do you want your wheel base strecthed or not.


once you answer those youll know what to do.
 
Don't need any lift, it has after markey over arched springs.

and I would arther keep everything as is so I don't create additional problems.
 
maybey there are other problems as well never had a problem with handling on any crusier when everything worked ok and was aligned right evae after all that work you may still have the same problem good luck
 
Replacing the worn parts and aligning the wheels works and is cheaper and easier.

x2. I replaced ALL the bushings in my springs with new poly units along with greasable bolts and new homemade shackles. VERY big improvement. Mine was so bad the springs would shift positions on the pins in a curve. Both scary and dangerous. Now it is much safer and easier to drive as well.
 
When I do the PS I’m going to go through all the linkage and alignment. I had heard from quite a few sources that this would help with the involuntary lane changes.
I’m new to cruisers I’ve always wanted one and got lucky a nice rusty one dropped into my lap for a very good price but like horses buying them is the cheep part!!
 
I haven’t looked at the brand but the prior owner spent a lot on the springs and shackles and the engine, ignition lucky me.
 
Start where I did. For about $150.00 had a BIG improvement. My old bushings and bolts were so worn both axels must have been hanging on for dear life. Worth every penney.
 
When I do the PS I’m going to go through all the linkage and alignment. I had heard from quite a few sources that this would help with the involuntary lane changes.
I’m new to cruisers I’ve always wanted one and got lucky a nice rusty one dropped into my lap for a very good price but like horses buying them is the cheep part!!





Welcome.



There are a littney of issues that can cause the truck to be difficult to keep in its own lane. First thing to verify is your caster angle. I would then look at the condition of the steering components all the way down to the knuckle. Knuckle bearings that are replaced and not installed with the proper pre-load, or those that are worn and damaged can also contribute to the issues that you are talking about.

Simply installing a shackle reversal based on the thinking that it will cure your handling issues is not a well thought out plan.




Good luck!


-Steve
 
If you have steering problems. then... fix the problems. There is no reason that you can not comfortably drive down the road at 75MPH on 36 inch tires with one hand on the wheel. With factory steering and suspension.


Mark...
 
Is there any reason to do the shackle reversal if you don't intend to get crazy in the rocks?
 
Is there any reason to do the shackle reversal if you don't intend to get crazy in the rocks?


I think it is supposed to make the cruiser ride better on the street..

If you believe in such a thing..
 
A shackle reversal is intended to improve higher speed on road manners. Not off road performance.


Mark...
 
Back
Top Bottom