A couple of years ago my rear diff was leaking badly from the front pinion. She who will be obeyed was giving me a lot of grief over it so I swapped in a new seal and called it a day. It hasn't leaked a drop since however, The old seal was bad - real bad.
Old & new seal comparison.
My issue now is that I have a whine when accelerating which I need to address.
My hypothesis is that rust from the old seal has compromised the bearing and my plan is to replace the bearing.
I have ordered a new companion flange, seal, bearing, crush sleeve and oil slinger.
Before I rip into this job I wanted to gain some feedback from the forum on whether this task is doable in my garage. The FSM steps look relatively straightforward but I have never messed with a diff before.
Any and all advice is greatly appreciated.
EDIT: - Forgot to mention this is on my '96 which has factory locking axles.
Old & new seal comparison.
My issue now is that I have a whine when accelerating which I need to address.
My hypothesis is that rust from the old seal has compromised the bearing and my plan is to replace the bearing.
I have ordered a new companion flange, seal, bearing, crush sleeve and oil slinger.
Before I rip into this job I wanted to gain some feedback from the forum on whether this task is doable in my garage. The FSM steps look relatively straightforward but I have never messed with a diff before.
Any and all advice is greatly appreciated.
EDIT: - Forgot to mention this is on my '96 which has factory locking axles.