60wag
Reactions
279

Latest activity Postings About Badges Post areas

    • 60wag
      Irwin loves the tailgate after a hard day of hiking.
    • 60wag
      60wag reacted to Heckraiser's post in the thread Auto locker up front? with Like Like.
      So the idea is a part time truck with manual hubs? IMO this is the best possible scenario for an auto locker in the front, but still far from good. I wouldn't want to run a trail hopping out at every obstacle to lock hub, then getting out after...
    • 60wag
      60wag replied to the thread '97 LX450 Steering Wheel Connector.
      My modified wheel controls still work. The 6 pin connector with the two missing pins is below the sheering shaft, no you don't have to remove the wheel. Just take the plastic covers off that are behind the wheel. I programmed the big button to...
    • 60wag
      60wag replied to the thread Bolt on turbo kit.
      The HVAC intake is at the base of the windshield (cowl) because it is a high pressure region. If it was low pressure, the blower would be working a lot harder to draw in outside air.
    • 60wag
      60wag reacted to peacesells63's post in the thread Bolt on turbo kit with Like Like.
      Sorry, something got all screwed up with that post, I meant to quote @CJK and the area by the cowl is a positive pressure area, not negative. I edited the original post. These are my louvers and they let air out of the engine compartment at slow...
    • 60wag
      60wag replied to the thread Gas tank gurgling noises.
      The better the charcoal canister vents, the lower the pressure in the tank, the more likely the ethanol-gas mixture is to boil. An old clogged up canister that produces high tank pressures might increase the boiling point just enough so its not...
    • 60wag
      The heater valve is at the end of its life, as is the charcoal canister line. All the rubber needs to be replaced. Probably ~$2000 in parts. It looks like the typical, moderately-neglected 80 that went for $3500 - $5000 pre-pandemic. If I...
    • 60wag
      60wag replied to the thread Engine won't rev past 2000 RPM(?).
      An exhaust restriction can cause the rev limit. For those with cats, that is a good place to start. Without cats, any chance the exhaust pipe has a large dent or crushed outlet?
    • 60wag
      60wag reacted to the stig's post in the thread Wits End Turbo Owners with Like Like.
      Pic for attention. Can someone send me the latest copy of the install instructions? I have one but it’s from 2019 and looks incomplete
    • 60wag
      60wag reacted to COYS's post in the thread What to do while instrument cluster is out? with Like Like.
      Just my internet opinion, but I find LEDs on a 90s vehicle to be a bit anachronistic. There's a certain warmth to incan bulbs that should remain as original. Not only did they last you a quarter century, but they're plenty bright enough. I see...
    • 60wag
      The weld spot on the head would scare me away. It must have been cracked to need the repair. This is a cast iron head right? Looks like the head bolt was in place when the weld was done, that means the head wasn't properly heated before the...
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top Bottom