Problem after Front End Rebuild

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 1, 2005
Threads
3
Messages
143
Location
Huntsville, AL
I just finished this job on my 80, along with upgrading to 100-series pads on new rotors. Now I have a noise coming from the front end that I'd describe as kind of a "light growl". It's not really like a brake squeal but more of a howl that begins about 15 mph. The volume and pitch rise slightly with speed but it becomes loudest when coasting. Application of the brakes does not quiet the noise. I can't feel any pulls or vibrations or detect any unusual drag.

I took care to apply plenty of grease to the bronze bushings in the spindles during reassembly, as well as the axle stubs under them. And I couldn't find any complaints of this kind regarding the upgrade to 100-series pads.

Anyone heard of this before? Thanks.
 
any vibration or wobble? sounds like the bearings may be overtight or insufficently lubed?
 
No vibes or wobbles that I can detect, just some mild noise.

I agree the bearings seem to be the most likely suspects here. But I did try to pack them as full as I could using both a Lisle packer and supplementing that with the gob-o-grease-in-hand technique. Used the Mobil 1 red synthetic per Romer's suggestion.

Pre-load set by torque wrench, as per the FSM, and verified using a fish scale. But this was my first time doing the job so who knows? I think I'll pull the wheels and recheck the pre-load.
 
Jack up your tire and grab it at the 6 and 12 oclock to see if there is movement pulling and pushing from the top and bottom. That would tell you if the bearings are loose.

How much moly grease in the knuckle?

by your description somethings seems to be not seated right or

Did you refill the fluid in the diff, sorry had to ask?
 
How much grease did you put in the spindle bushings? It seems like most GRRRR noises following repacks are due to insufficiently lubed spindle bushings.
 
Did you refill the fluid in the diff, sorry had to ask?

:eek: OMG Ken, thanks for asking! That is so like me, I was very careful to do everything just so, by the book. But I just realized, yes, I forgot to refill the diff!!!

I've probably driven it about 10 miles total since buttoning it back up. How much damage do you suppose I've done???
 
My guess is your dif is fine. I bought one of my 1st 40's and drove it home from San Diego to San Francisco.

Started going through it only to find that it had no fluid and in the rear dif or transfer case. (60 K later its doing just fine even with lots of Rubicon abuse)

Hope that gives you alittle peace of mind. Good luck!
 
I would fill with new oil .. ride test for a few milles and check it again, just to see uf you have evidence of damage in the oil ..
 
Back
Top Bottom