Part Time Regret?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 31, 2014
Threads
11
Messages
173
Location
Westminster, CO
I have a set of crawler gears that is going into the transfer case over the winter. However, having just put 37s on the rig I'm also wondering if a part time kit might not be smart to do at the same time. It's not a daily, and despite living in CO I really don't take it out in the snow.

I've read through some threads about people being happy with their part time conversion - better steering feel, fix driveline vibes, extend life of cro-mo axles, easier to get home from a break, etc. Has anyone gone part time and regretted it? The biggest negative I could see is that I do like being able to occasionally unlock the center while in 4 low for a tight turn, but keep all 4 wheels powered.
 
I've thought about this, and wondered if just adding the locking hubs and disconnecting the front drive shaft from the transfer case (and suitably securing it, maybe with a ratchet strap between the frame rails) would offer the best of both worlds.

With that, you could:
  • Drive in RWD with the hubs unlocked, CDL on and drive shaft disconnected
  • Drive in RWD with the hubs unlocked, CDL on and drive shaft connected (but spinning the front axle pointlessly)
  • Drive in AWD with the hubs locked, CDL off, and drive shaft connected (Normal 80 operation)
  • Drive in 4WD with the hubs locked, CDL on, and drive shaft connected (Normal 80 operation)
With the part time kit inside the TC you of course lose the "AWD" option.
 
I have the Slee part time kit and I think there is way more benefit to having it then not having it, especially in the Denver Colorado metro area where you have to do emissions testing every two years. Now I do not have to drive on the full time 4WD rollers, I can just do the rears without having to remove the front drive shaft. Less resistance should equal less emissions right? Plus the emissions testing centers only can test up to a 34" tire on the full time 4WD rollers without have to put on some rinky dink tires to get it to pass. JMTC.
 
I added manual hubs on mine, but I'm not willing to do the TC mods and lose AWD, it's winter conditions 4-5 months of the year here, and the reported fuel economy savings do nothing to steer me away from AWD.
 
I have the Slee part time kit and I think there is way more benefit to having it then not having it, especially in the Denver Colorado metro area where you have to do emissions testing every two years. Now I do not have to drive on the full time 4WD rollers, I can just do the rears without having to remove the front drive shaft. Less resistance should equal less emissions right? Plus the emissions testing centers only can test up to a 34" tire on the full time 4WD rollers without have to put on some rinky dink tires to get it to pass. JMTC.

Meaning the 2wd rollers can do 37s? I was not aware of that. That in and of itself would make me do it. I just passed on my old 34s before switching to 37s, but was just planning on driving by some of the vans they park on highway on ramps.
 
No regrets. Lokka locker. Drives just as good in the snow as before with 37's. Save the wear on gears, longfields, and drive shaft. It's a no brainer imo. Wish I put the low range in there at same time. Oh well ill be opening it back up soon.
 
On the sh!tty paved roads around Calgaryfor 1/3 of the year I wish I had an AWD t-case vs. my 60 series case.

I've been pondering a way to go to a full time again, (running 6BT, NV4500 AA adapter to 60 series split case). 4WD sucks on highways and paved roads around the winter months IMO.
 
Barring the possible savings on fuel, I have yet to read a genuine and credible reason to change to PT.

regards

Dave

No vibs is enough reason to go PT
 
Correct no lift but fitted a OME 2.5 inch lift to an 80, no vibes but steering wandered the moment you relaxed, changed to offset bushes and never another issue. Perhaps higher lifts give issues? Did a 4 inch lift on my Discovery and that did vibrate badly, went with the DC front prop and no more vibes. I guess some cars are more prone than others and money has to be spent to counter it, perhaps a PT kit is the easiest and proven way out?

regards

Dave
 
I wouldn't hesitate to go PT again. Drivability factor, turning radius and no vibrations all great benefits and living in the SW no need to full time.

That said, if I lived in a wet / snowy climate such as the Northwest I would heavily consider staying full time.
 
Back
Top Bottom