Oil leaks

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 15, 2005
Threads
29
Messages
121
Location
Leesburg, VA
As part of my other post about changing the oil in the tranny, diff and Tcase..... I removed the skid plate and found two leaks.... here are some pics.. anyone have any thoughts about what these leaks are from...

Also......thanks for the help locating the fill plugs...... I labled which ones I think are correct? Am I right?
 
Last edited:
Hi All:

Nice pics! That transfer case is sooo clean! One could "eat off of it!" :grinpimp:

The photos show a front output shaft leak, and a leak where the speed cable attaches.

There is a seal you can replace under the flange on the front output shaft. There is a felt washer inside of the screw-on fitting that attaches the speedo cable to the output shaft extension housing.

Do you have a 40 Series repair manual? It should have the specs for the torque setting of the front output shaft nut.

Good luck!

Alan
 
the second picture shows the speedo cable; there are two different sized o-rings in there that can become bad. They can be found at a regular hardware store. I just bought one of each size, and two of the were the right ones ;)

what also happens when the speedo cable itsn't tight is that the speed indicator needle on the insturment panel starts to wiggle regularly. Ask me how I know ;p
 
It appears others have accurately addressed most of the sources of your leaks. Regarding the leak on the idler shaft, mine too leaked and a new O-ring on it made no difference. What I did was to spray it with brake kleen, let it dry a few minutes and smear 1/2 tube of clear silicone on it spreading it around with my finger, over lapping about 1/2" out onto the cast aluminum housing. Not very scientific and certainly not real pretty but no more leaks.
 
Last edited:
Back
Top Bottom