No high beams

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 11, 2005
Threads
75
Messages
345
Location
OKLAHOMA cITY
Howdy all, I did a search, but didn't see this issue.

My high beams don't turn on when I turn them on when I push the signal stalk forward to turn them on, but they DO turn on when I pull the stalk back to flash the high beams.
It could be the switch at the steering column, but wondered if there was a separate relay for the high beams that I am missing.

Thanks for the help!
 
I had this happen before but I can't remember what it was now off the top of my head :doh:. Hopefully it comes back to me and hasn't been purged for some other worthless piece of trivia.
 
With the low beams off pushing the stalk forward does NOT turn the high beams on. The low beams have to be on for pushing the stalk forward to turn the high beams on. Pulling the stalk back always turns the high beams on regardless of whether the low beams are on or off.
 
I have the same problem in my '92. I pulled apart the switch and cleaned up the contacts, it worked for one day then went back to dysfunction. Next up I am going to try a switch from a '94 Camry, going to grabbed the window switches as well...
 
Can someone post a pic of the contacts that everyone says to clean. I am pulling the covers off the column now and I see the headlight control arm linking to a module that has several soldered wires on the back side? A pic would really help!
 
not sure if your US 80s are wired the same as my UK 1HDT, but if so you should check the black (main beam) relay in the fusebox.

I've had no end of issues with mine, replaced twice, cleaned contacts etc, finally had to cut up the fuseboard a bit, a few weeks back as the wires underneath it, joining fuseholders to relays etc had perished/melted, causing fuses to blow and the relay contacts to burn out quickly.

we ended up cutting out the 2 main beam fuses, and the relay holder, and remaking the wires. pic here
 
JohnVee - Which pic shows the contacts that I need to clean? Getting ready to head out to the garage right now to get it done.
 
Just replace the switch. Cleaning the contacts will only work for a short period of time and in the end, they will not make contact... that was my experience anyway. Wish I would have replaced it in the beginning instead of having to spend the extra time pulling everything apart again.
 
I recently went through this and didn't take many pictures, but I did take mine apart twice. Cleaning the contacts did not work, but I did have a used switch off my brother in laws wrecked 80. I pulled the entire "assembly" off his and brought it home. When I attempted to disconnect just the dimmer switch from the rest of the switches, I couldn't figure it out. i didn't want to break all the plastic connections since it was very cold the day I was doing it. So, I just replaced the whole assembly. I was afraid of all those plastic connections breaking as I tried to remove just the dimmer switch. Here is a pic of the entire assembly that I swapped out. Works good now. I forgot what high beams were...

IMG_2573.webp


IMG_2574.webp
 
Absolutely Appreciate the Pics!! Thanks brother!
 
Can I just replace the headlight control module on the combo switch? I am having a hard time finding the entire combo switch used for my 93 LC 80 with cruise.
 
Back
Top Bottom