Hello everyone,
Moving to northern Arizona ( Williams Az) looking for a shop for my 40 and 62 any recommendations?
Moving to northern Arizona ( Williams Az) looking for a shop for my 40 and 62 any recommendations?
Moving to Williams Az
- Thread starter vcrusher
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I think it is Higgys down in the valley... Never been myself, but lived in Show Low for a bit.
Anywhere but Vintage Cruisers - keep it away from Mushro.
There is a sub section of Copper State Cruisers that meets in Flagstaff. Should be able to get recommendations from members there. Unfortunately @kelly saad moved his shop from Flagstaff to Cottonwood. Still a lot closer than Higgys in the southeast Phoenix metro area.
Haven't heard anything about him in a long time. Is he still around. Has a shop in Flagstaff if I remember correctly. Never dealt with him but would still avoid him.
Not sure if he still has a home in Prescott Valley. Last I heard he was working and living the the Phoenix metro area.
- Thread starter
- #9
Thank you.
@kelly saad doesn't do mechanical work. He is a paint and body/assembly shop.
@peacesells63 is in Flagstaff and I believe runs a shop working on Land Cruisers? (could be wrong).
Scott is in Mesa.
We are on the other side of the state in Sonoita (but we get people from all across the US bringing their trucks to us)
@peacesells63 is in Flagstaff and I believe runs a shop working on Land Cruisers? (could be wrong).
Scott is in Mesa.
We are on the other side of the state in Sonoita (but we get people from all across the US bringing their trucks to us)
I do, just started up at the end of summer - thanks for the mention!
@vcrusher, feel to reach out via PM for anything you need.
Nice. Good to know. Good luck with your venture. Wrenching on LCs sucks donkeyballz.....
can't wait to spend some time at Rubithon, need to get Alvaro's arse to make an appearance, havent seen his daughter in a minute & I miss the big guy & the food. Does anyone know if Brantley ( Pismojim ) is still alive ?
Thank you! It has been much busier thank expected so farNice. Good to know. Good luck with your venture. Wrenching on LCs sucks donkeyballz.....
Definitely an odd move leaving a 6 figure career to wrench on crusty old junk, but the management and co-workers here are excellent
- Thread starter
- #16
Thank you.
Brantley retired and moved to MT last I heard.
We are all greatly appreciative to have @peacesells63 here working on our Land Cruisers!
