This is the gasket for the windshield vent , looking for contact to purchase one.
Looking for vendor that supplies vent cowl rubber gasket
- Thread starter Nifski
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Cowl Vent/Damper Gasket for Land Cruiser FJ40
Cowl vent/damper gasket for Toyota Land Cruiser FJ40. Fits all years with a functional vent ('73 and earlier in the U.S. Market; through end of production in Middle East, South American and other select markets). Replace your disintegrated old gasket with our highly robust replacement that...
www.cityracerllc.com
I think he means the flap at the bottom of the windshield.
SOR part #
120-11-A
Might be other vendors.
I’ve had to replace mine several times if you open/close frequently.
I keep a couple on the shelf because of it.
120-11-A
Might be other vendors.
I’ve had to replace mine several times if you open/close frequently.
I keep a couple on the shelf because of it.
Last edited:
Cowl Vent/Damper Gasket for Land Cruiser FJ40
Cowl vent/damper gasket for Toyota Land Cruiser FJ40. Fits all years with a functional vent ('73 and earlier in the U.S. Market; through end of production in Middle East, South American and other select markets). Replace your disintegrated old gasket with our highly robust replacement that...www.cityracerllc.com
Thanks for posting this. Was NLA forever. Glad it’s being reproduced.
- Thread starter
- #7
Sorry, this is for the early windshield with the turn knob to open the linear vent just below the windshield, we are working on a 1964. you can see the one on my sig line
- Thread starter
- #9
It’s down at the shop, I saw that SOR has some, are there two different versions?
There’s only one gasket, but there’s two different methods the two metal pieces attach. The early version was spot welded together (PITA) and by around 1963-1964 they started using stud/nuts.
- Thread starter
- #11
Thx, crossing my fingers it’s bolted!@cruiserhiggins
I have a good upper part with good studs if yours are bad or break.
^This. I’d suggest using a nut driver to start. A lot harder to break off rather than a ratchet.
Anyone come up with a better durometer rubber sheet? Curious. I have a sor repro would be willing to copy
^ I’ve wondered about this as well. Maybe cityracer would be willing to tackle?
I’d have to compare the 2 but I have a NOS OEM version too. Been saving it so it could be copied someday.
I’d have to compare the 2 but I have a NOS OEM version too. Been saving it so it could be copied someday.
Well, you asked. I know if someone used a high quality EPDM vs. what OR is using, they would have customers.
McMaster-Carr - https://www.mcmaster.com/gaskets/rubber/
I'll order some, copy the gasket b4 instal and report back
I’d be up for buying a few.
I dug out what I have. Not NOS after all but in very good shape if you need any measurements etc.
OEM has a small lip on one side unlike the repops but I can’t imagine it would be worth the effort to recreate.
I dug out what I have. Not NOS after all but in very good shape if you need any measurements etc.
OEM has a small lip on one side unlike the repops but I can’t imagine it would be worth the effort to recreate.
