Long-term Aussie locker experience

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

80t0ylc said:
Obviously, you need to polish your reading skills. None of my statements called the Aussie bad. Just opinions like yours. (I don't have to fall of a cliff to know that I don't want to.) I'm glad that you're having good luck with yours. Just gives me more confidence it will work for my use when I install one. Just not in a rig that I drive in winter for highway use. We live in different areas of the country and different road conditions. So lets just leave it at that.

You haven't necessarily called it bad, but you've done your best to discredit it's winter performance without actually ever had one.
I am in the snow all winter long and other than the slight side pull that can happen in off camber situations (which is simply remedied by letting off the gas), the Aussie has been fantastic in the snow and slick stuff. I've also had zero issues on road, with my only complaint being the ratcheting in tight, slow, turns.
You're speaking like an expert, with what seems to be nothing other than opinion to back what your saying.
 
Obviously, you need to polish your reading skills. None of my statements called the Aussie bad. Just opinions like yours. (I don't have to fall of a cliff to know that I don't want to.) I'm glad that you're having good luck with yours. Just gives me more confidence it will work for my use when I install one. Just not in a rig that I drive in winter for highway use. We live in different areas of the country and different road conditions. So lets just leave it at that.

Keep in mind that having a aussie-locked rear end in an AWD 80 is probably very different than having an aussie locked rear in a RWD/4WD setup. I in my BJ73 w/ rear aussie locker, icy roads were definitely a concern, but I think it might be alot more civilized in an AWD system.
 
Keep in mind that having a aussie-locked rear end in an AWD 80 is probably very different than having an aussie locked rear in a RWD/4WD setup. I in my BJ73 w/ rear aussie locker, icy roads were definitely a concern, but I think it might be alot more civilized in an AWD system.


x2

I had a lockrite in the back of my FJ60 and you could definitely feel it while driving on any icy/snowy road. I have an Aussie in the rear of my 80 and I have never slipped or got squirrelly while driving it in ice/snow. I even used my 80 on an icy/snowy hill to pull another SUV that was stuck and I never spun a tire. The AWD system makes a definite difference in the feel.
 
Keep in mind that having a aussie-locked rear end in an AWD 80 is probably very different than having an aussie locked rear in a RWD/4WD setup. I in my BJ73 w/ rear aussie locker, icy roads were definitely a concern, but I think it might be alot more civilized in an AWD system.

x2

I had a lockrite in the back of my FJ60 and you could definitely feel it while driving on any icy/snowy road. I have an Aussie in the rear of my 80 and I have never slipped or got squirrelly while driving it in ice/snow. I even used my 80 on an icy/snowy hill to pull another SUV that was stuck and I never spun a tire. The AWD system makes a definite difference in the feel.
This is the kind of feedback we need to give the OP the info that he is asking for!!! Not just - yeah the Aussie works great.

There is a difference in the stock 80's (open diffs) handling being AWD. Mine is open, no e-lockers. I run Green Diamond Icelander M/Ts (not studded) and the handling is better than any rig I've ever driven on ice and snow packed roads, even rigs with studs. The rigs I've driven with Detroits were part time. Even with hubs & 4WD engaged they didn't hold a candle to my unlocked stock 80 on icy roads. I can't imagine an Aussie improving on that except in off road, tight camber situations. I'm just concerned with how it would affect road manners. These 2 posts have given some valuble specific info. Thanks! :cheers:
 
No matter the merits of these lockers , one thing is sure , they are made well. Just removed mine to replace with ARB
After a few years they show no wear at all

img_3114.jpeg


img_3115.jpeg


img_3117.jpeg


img_3118.jpeg
 
It's true, in off camber situations, especially when backing up on icy or snow covered roads I would prefer an open rear diff to an auto locker.

That said, I've driven my lockrite equipped AWD 80 on plenty of slick surfaces. No issues on my km2s on snowy roads.

Yep, you can get oversteer when accelerating on slippery surfaces. So avoid gassing it in a turn.

The cost-benefit ratio is very good. And most of the time i prefer an auto locker when off pavement. I also usually wheel with the CDL unlocked until I get to an obstacle.

Ymmv

Be aware that the road manners do change with any auto locker. Learn to drive it and you'll be fine.
 
It's true, in off camber situations, especially when backing up on icy or snow covered roads I would prefer an open rear diff to an auto locker.

That said, I've driven my lockrite equipped AWD 80 on plenty of slick surfaces. No issues on my km2s on snowy roads.

Yep, you can get oversteer when accelerating on slippery surfaces. So avoid gassing it in a turn.

The cost-benefit ratio is very good. And most of the time i prefer an auto locker when off pavement. I also usually wheel with the CDL unlocked until I get to an obstacle.

Ymmv

Be aware that the road manners do change with any auto locker. Learn to drive it and you'll be fine.

This has been may experience as well. Same with engaging the CDL while wheeling.
 
No matter the merits of these lockers , one thing is sure , they are made well. Just removed mine to replace with ARB
After a few years they show no wear at all

Does that mean you are selling yours? If so, let me know!

Sent from my iPhone using IH8MUD
 
Forgive me for being uninformed but do these Aussie lockers function more like a limited slip diff or welded diff? What I mean is that when turning, do you get the inner wheel spin like you would on a welded diff or does it allow for different turning speeds of the inner and outer wheel?
 
retrofive said:
This has been may experience as well. Same with engaging the CDL while wheeling.

Why wouldn't you guys engage the CDL? Just to disable the ABS on dirt is all the reason I need to hit the CDL as soon as I hit the dirt!

Sent from my iPhone using IH8MUD App
 
they work like auto lockers .. they allow the external wheel of the axle on turn to spin faster .. ( never slower )
 
Forgive me for being uninformed but do these Aussie lockers function more like a limited slip diff or welded diff? What I mean is that when turning, do you get the inner wheel spin like you would on a welded diff or does it allow for different turning speeds of the inner and outer wheel?

No.

Automatic locking differentials (Detroit, Aussie, lockrite, etc) only lock both wheels together at the same rotational speed when one or more wheel loses traction and slips. At all other times, one side is driving and the other side (that is rotating faster) is free wheeling or ratcheting. The driving side switches when you change turning directions and when you go back and forth between drive and coast. Some people mistake this side switching for "locking".

Only one side can rotate faster than the ring gear, but neither side can rotate slower.

Pretty simple, no?

Here is a link to an explanation of how they work that I wrote up for a class.
https://webfiles.uci.edu/cglabe/Documents/LockerOperation copy.pdf?uniq=5c5xw2
 
Last edited:
IOW it feels sort of like a limited slip, but with dog clutches instead of friction clutches. More abrupt and harder locking. And will allow you to move even when the opposite tire is in the air. Like a welded diff, but streetable
 
Why wouldn't you guys engage the CDL? Just to disable the ABS on dirt is all the reason I need to hit the CDL as soon as I hit the dirt!

Sent from my iPhone using IH8MUD App

I leave the cdl disengaged because I don't like how much the drivetrain binds. So I just hit the cdl button for difficult obstacles. Haven't had any problems with abs yet.

Also to go along with this thread I have had an Aussie locker for about 3 years and no problems at all. Probably the best mod I have done.
 
With auto lockers you just gotta slow down in turns and cornering. Me - I like open diffs. I don't do any hard core wheeling anymore and open diferretials make more sense.
 
No.

Automatic locking differentials (Detroit, Aussie, lockrite, etc) only lock both wheels together at the same rotational speed when one or more wheel loses traction and slips. At all other times, one side is driving and the other side (that is rotating faster) is free wheeling or ratcheting. The driving side switches when you change turning directions and when you go back and forth between drive and coast. Some people mistake this side switching for "locking".

Only one side can rotate faster than the ring gear, but neither side can rotate slower.

Pretty simple, no?

Here is a link to an explanation of how they work that I wrote up for a class.
https://webfiles.uci.edu/cglabe/Documents/LockerOperation copy.pdf?uniq=5c5xw2

Good info, thanks. I can see myself picking one of these up in the near future... They appear to be back in stock on the website and you cant beat $300 for a locking rear end. I'm used to seeing parts like this being in the $1k range.
 
Why wouldn't you guys engage the CDL? Just to disable the ABS on dirt is all the reason I need to hit the CDL as soon as I hit the dirt!

Sent from my iPhone using IH8MUD App

Honestly just for fun. CDL locked and wheeling makes things a little too easy at times.
 
I have a 97 FZJ80 40th. Sorry if this is hijacking but I can't fit an Aussie if I have a rear LSD correct?
 
Back
Top Bottom