LCLC HAM Thread (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Classes? Please clarify.

Since it is past @CharlestonG8R bedtime, he has a Boeing co-worker that teaches a HAM class. All day training Saturday session, review and test on Sunday. Offered at Boeing, as far as I know. And little or no cost... I believe.
 
The class is free, but the test fee is $15
 
Oh!!!! A class for nerds is all you had to say.
 
Sweet jeebus that was a terrible read. I hope I can forget having read it. Damn you, Jeremy. But it did make for a good insult.
If it didn't relate to an inside joke, it would be an insult below the belt... I apologize to anyone that read the article and thought, even for a moment, that this method of cooking meat was acceptable.
 
A big thank you to @forrest5000 for mud-shipping my lift kit to the HAM class. I'm still not sure if I can take the class, but if I can't at least meet Eric this weekend, would someone be able to get the springs for me? Thanks.
 
Sorry to do this last minute, but looking like I'm not going to make it to the class after all.
 
I ordered an external antenna for my hand held off Amazon for $12.99
 
@CharlestonG8R - I know it is late, but is this still on for this weekend? I plan to be at the visitors center before 8AM...
 
T-minus 35 minutes until test time. Time for a beer and a gyro
 
They teach the test.... you just have to memorize the answers.

I could only memorize 34. Of the 26 that I needed to pass. :beer:
 

Users who are viewing this thread

Back
Top Bottom