Is there a "Best" knuckle rebuild kit, or.... ?
- Thread starter ElPatudo
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
This topic will bring back a lot of memories....!!
In theory OEM Toyota parts a best.
Last edited:
I tried to use an aftermarket kit the first time I did this, I think it was an Aussie company's kit. The felts were too thick and I struggled to get the tiny 6–mm screws into the knuckle. I finally gave up and used longer scews. PITA
I only use Toyota parts for this now.
I only use Toyota parts for this now.
- Thread starter
- #7
Already been having flashbacks for a while now
Does anyone sell a OEM Kit for this??
Kurt @cruiseroutfit is also a great source
- Joined
- Jul 22, 2012
- Threads
- 638
- Messages
- 17,375
- Location
- Winter Park, Florida
- Website
- www.cruisermatts.com
8x/105 Series Knuckle Rebuild Kit
Sumo Japan Knuckle Rebuild Kit Fits 80/81 Series LandCruiser 1/90-1/98. Also Fits 105 LandCruiser. One kit required per vehicle! Wheel Bearings available separately: Here! SUMO GEAR knuckle rebuild kits are built using parts sourced from the original manufacturers that supply Toyota, ensuring...
cruisermatts.com
Koyo Wheel Bearing Set 40/55/60/70/80 Series
Suitable for solid-axle Land Cruiser models 1975-Newer. Need the full knuckle kit? Available here! 40/55/60 Series, 70 Series, 80 Series Just doing the wheel bearings? Hub gasket, seal, and lock washer available here! If you have any questions about compatibility or installation, please do not...
cruisermatts.com
Last edited:
Already been having flashbacks for a while now
Does anyone sell a OEM Kit for this??
If you want Genuine OEM parts for the rebuild, here you go. You can pick them up from Sierra Toyota, Peter.
90366-20003 x4
43204-60032 x2
43422-60060 x2
90520-31007 x2
90179-12021 x8
90126-12010 x8
90116-08325 x12
42323-60010 x12
90311-62001 x2
90310-35010 x2
12157-10010 x2
90214-42030 x2
90215-42025 x2
43521-60011 x4
90170-08204 x12
90368-49084-77 x2
90080-36067 x2
43435-60020 x2
43436-60011 x2
90313-93003 x2
That’s what picture are forYIKES! It's times like this I need a photographic memory!
Gracias
or a screenshot
Terrain tamer HD
Spend a few extra $$ and replace to old studs and cone washers with new. As old as these 80s are now you never know what wrench monkey has had his hands on the knuckle hardware and beat the snot out of it or over tightened.
That's the set I used that gave me so much trouble...never again.
These are good additions as well, though I would leave out the 94115-71200 and go with the much better (labeled above) 90179-12021 instead.
What makes the 90179-12021 the better choice? Looks like they are about the same $$
They come pre-coated with thread locker as well as being a flange nut vs. just a hexagonal nut.