Is it a good one?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Hear are a couple of the other pics i got from the owner.

fj40_4.jpg


fj40_5.jpg


as for 3 on the tree, i think so.. i dont have any dash shots and per my reading in the FAQ section the 4 speed didnt come around till what 75 (ish or something)

As for the rust, ya i hear what you guys are saying but hear in the midwest, thats the best ive seen in a long time for the "entry level" non already restored version that im looking for.

As for my skills the rust doesnt phase me much. I currently do body work on my stuff (cut and weld repair pannels etc) and am just finishing up putting my rebuilt motor back in my 92 runner so ya i got some skilz and a shop to back it.

The others ive come across in the past years have consisted of little more than rusted out hulks with half swaped out drive trains that didnt run, or worse, and were missing half the body pannels....

Its a tough go hear in the midwest.. (or im not looking in the right locations one of the two)
 
snap-on said:
The other thing that caught my eye as "odd" was the roll bar design. Not what i usually think of for the FJ rear roll bar design.

The rear part of my roll cage looks this way, too. Aftermarket.
 
Thanks John, for the tank clarification. Any tank that could have been is certainly gone from my rig. I do have a charcoal cannister in the engine bay, though. Come to think if it, yes, there could have been a few more holes in the wheel well among the ones for the Confer bench in the rear. Now they are sheathed between two thick layers of steel anyway to make up for weakness from rust ;p Thanks again.
 
My .02

I live in the midwest too, and I actually see a lot of potential in this rig. The main thing, which was already said a few times, is to make sure that there's no serious underlying issues like frame rot or major panel repair in it's future. You want to make sure that the good deal at $1.5 - 2k doesn't turn into a $5 - $6 so so deal before your are truly happy with it. Make sure to weigh out all of the realistic costs and let good judgement and not emotion guide your decision. Good luck and I hope that this turns out to be the one for you! :beer:

Clint
 
Cruiser Clint said:
You want to make sure that the good deal at $1.5 - 2k doesn't turn into a $5 - $6 so so deal before your are truly happy with it.

I think that is unavoidable in this case ;)
 
wantatlc said:
I think that is unavoidable in this case ;)

not only in this case, I'd venture to say you put a pretty coin into any cruiser on top of what the purchase price is.
 
DSRTRDR said:
not only in this case, I'd venture to say you put a pretty coin into any cruiser on top of what the purchase price is.

true true.. but I guess I thought that one went without saying :cool:
 
A good rule of thumb with any cruiser, whatever the price and time you think it will require to get it to your "standards" - DOUBLE IT! I will say from your pictures, that looks like some pretty extensive cancer. From past experiences, I would not purchase a vehicle with that much exterior rust.... but just my .02 cents! Its your $$$ and if you walk away happy, thats all that matters :) good luck!
 
Back
Top Bottom