How’s this spindle?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 19, 2013
Threads
38
Messages
562
Location
Eastvale, CA 92880
I really don’t know how to tell if the bushing or the spindle is worn and needs to be replaced. I don’t want to replace it if its not needed. So here are some pics.

2EB3C63C-D9FA-4955-B305-AF12B199EED9.webp


3ABE74E4-1904-479F-BD46-C646F2BF85B2.webp


38591ABC-64E0-46AE-9A25-7B19545C766D.webp


F2848724-79E8-4B90-9C22-A9AA317F611C.webp


B30F6313-30CC-43AA-8587-2172D0F62B4B.webp
 
The bushing looks OK from what I can see. It would help if you cleaned the grease off before taking the picture. You need to degrease and clean before regreasing anyway. The surface at the base of the spindle where the hub seal rides would be my concern if there are groves where the old seal rode. Can't determine that from the picture as it just could be discoloration without groves.
 
Nothing wrong withe that spindle or bushing. Clean them up and regrease, and run.

Use some ScotchBrite on the black line on the spindle where the seal rides, and it should clean up nicely. Check to make sure there isn't a groove cut in it. If there is, be conscious of that when you install the seal in the hub to either under-drive it or over-drive it so it's not riding in the exact same spot.

Don't forget to wipe grease on the shaft and the seal before assembly.
 
If there is a significant wear step running between 3 and 9 O'clock along the underside of the spindle tube where the outer bearing sits the bearings may not hold preload.
 
Back
Top Bottom