Holey Panel... Batman!!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

TexFJ

SILVER Star
Joined
Jan 11, 2020
Threads
59
Messages
1,030
Location
Texas
I have a case of Swiss cheese on my front panel. I'm trying to decide what is a stock hole and what was created by the many overzelous owners of this 1973 FJ40.

Screen Shot 2021-10-29 at 9.29.08 AM.webp


Here's what the 1973 FJ40 looks like in the LC Museum. The panel looks like it's completely different.

Screen Shot 2021-10-29 at 9.12.52 AM.webp
 
I took a stab at what I think is factory. Factory holes circled in red. Included radio, ash tray and lower dash pad clip holes. Edit: I forgot to circle the upper dash pad holes.
ECE5742C-17B9-4BC9-B82A-487F4B82166E.jpeg
 
Looks like Byron and I circled the same stuff. Phew!
 
The original owner of my '73 loved illuminated toggle switches and the cheap Kmart fog lights. I removed 14 toggle switches from the dash, placed a small piece of 16 gauge sheet metal behind each hole and welded them all shut. A tiny bit of body filler to take care of any pin holes sand the entire dash down and repaint it while painting the body. Just don't look behind the dash.
 
The original owner of my '73 loved illuminated toggle switches and the cheap Kmart fog lights. I removed 14 toggle switches from the dash, placed a small piece of 16 gauge sheet metal behind each hole and welded them all shut. A tiny bit of body filler to take care of any pin holes sand the entire dash down and repaint it while painting the body. Just don't look behind the dash.
Nice, I guess it's much easier if you hav an overlap when welding thin sheet metal. I like that idea of bonding after wards. My attempts at welding up the roof rack holes on my 80 were stressful as hell, burn through is a witch.

Other option is installing a new panel.
 
Make little 'coins' from the same or thicker sheet metal to fit the holes, hold them in place with a magnet from the backside to tack them in, then finish weld. Use an orbital sander to smooth the surface.
 
Also note that many of the original holes in the dash had backer plates welded to the dash panel on the back side. These plates have slots at the bottom that mate with tabs on the switches to keep them from rotating.
View attachment 2825423
This is awesome! I didn’t know that.
 
Here is my replacement dash from a 73 FHT. I have new 73 owners manual I bought shortly after buying my 73. Only thing I notice different is the location bracket for cowl vent handle is further left than they actually are.The hole above the glovebox and one just to the right of the Vader light hole were obviously from a aftermarket grab bar. Can see where the paint isn't faded.
To the right of that see three small holes guessing may have been from can holder you see on a boat.

Not sure when I picked the replacement dash. Sure it was in the nineties. Friend was parting out a 73. He past away quite a while ago. Can post pictures from the owne's manual of locations of everything on the dash if anyone ones.
20211030_162111.webp
20211030_161826.webp
20211030_161800.webp
20211030_161809.webp
20211030_161711.webp
 
Last edited:
Back
Top Bottom