Hand Throttle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 6, 2007
Threads
352
Messages
3,413
Location
San Juan Puerto Rico
Website
www.facebook.com
Where I can get a hand throttle for my 92 FJ80?
 
I've got one here in Aus no longer needed as I'm DBW. If the pedal set up is the same as a FJZ it will fit straight on.
 
i ordered one from Ebay, looks to be OEM and came in a toyota bag with the PN on it. still need a bracket for the pedal.
 
Looked on Ebay, no luck. Found some universal, and some for Jeep wranglers...
 
OEM is not always perfect. Some people complain about it. Read a little before you throw your money at something you might not like.
The Toro cable is only $15, plus some nuts and washer you might already have in your garage.
 
OEM is not always perfect. Some people complain about it. Read a little before you throw your money at something you might not like.
The Toro cable is only $15, plus some nuts and washer you might already have in your garage.
OEM is not always perfect. Some people complain about it. Read a little before you throw your money at something you might not like.
The Toro cable is only $15, plus some nuts and washer you might already have in your garage.

I'm going to check on the Toro cable. The main issue is how to rig it to the pedal which probably is not a big deal...Thanks!
 
If i remember right in order for this to work on your 92, you'll need to get a late model (93 1/2 to 97) gas pedal to work with the factory hand throttle. The reason for that is, the late model gas pedal has a "J" shaped bracket welded on it to hold the hand throttle cable end in place, that the early trucks didn't come with. I just bought my hand throttle for my 94 from Akella a few months ago, total with shipping was 49 bucks.
 
Last edited:
Does the use of this come up very often? Winching? I know what the plug is for on both of mine, but I've never conjured up a need. Thought about putting a switch in that little round hole.
 
Winching and Air compressor are my main needs. Could be helpful when jumping and recharging another vehicle or battery I guess.
 
I think the use for comes up often enoigh that i like having the option. It is pretty cheap considering the money we spend on our crusers.

The oem one has the plastic knob held on by only a small metal clip. I thin that is what people break when pulling on it. The thinyois you shouldnt be pulling on it. You turn it to unlock it. Set the throttle position with your foot on the peddle. Then use the knob to take up the slack and turn to lock it in that poaition. Very little force is put on the knob.
It works well in this way. But i do think the normal idea would be to pull the knob and i wish it was designed to work better in that way.
 
I have the OEM one from ebay. It was an easy install on my '93. I use it when winching, air compressing, jump-starting, charging another vehicle, AC inverting, warming up or cooling off the interior, and low-speed very bumpy wheeling. I actually use it a lot more than I ever thought I would.

I did have to cut a notch into the bracket above the gas pedal in order to land the hand throttle cable. Apparently some have the notch and others do not.
 
Back
Top Bottom