Got any ideas?

[Dustins94toy]

Can you guys post some pics or give me some ideas how to fit all this s*** in this little truck!! Im trying to keep the original gauges and put after market oil, temp, volt, tach, cb, small fire extinguisher, keep the cd player, like to keep the glove box, cant use middle planning to put duel transfer cases and have to stay away from dash Ive got a club sticker on the upper windsheild that takes up most of it so i need the dash to see out of. Any ideas or pics??

 

[WarDamnEagle]

Search "Pillar Gauge" in a few of the forums. I know you'll get some hits in the 80 section that will be helpful.

 

[Dustins94toy]

I thought about that were do i need to go to get one??

 

[WarDamnEagle]

I found this link in 1 minute by looking at the FAQ (thread in the top sticky section of this forum). It was listed under the "interior mods section". The FAQ has lot's of great info if you haven't read through it yet.

Welcome

 

[Dustins94toy]

Thinks didnt know do now.

 

[Dustins94toy]

I would still like it if someone could post some pics of there interiors.

 

[GRM]

Can you guys post some pics or give me some ideas how to fit all this s*** in this little truck!! Im trying to keep the original gauges and put after market oil, temp, volt, tach, cb, small fire extinguisher, keep the cd player, like to keep the glove box, cant use middle planning to put duel transfer cases and have to stay away from dash Ive got a club sticker on the upper windsheild that takes up most of it so i need the dash to see out of. Any ideas or pics??

I'll take some pictures tomorrow but...

I have the factory tach and volt. There is enough room for 2 aftermarket gauges in the lower part of the cluster bezel. CB is through the dash (but I lost the passenger side heater vent in the process), CD player is in the Tuffy console (I have single cases), and replaced the factory stereo location with a 12voltguy.com switch panel.

It would also be easy to put the CB below my switch panel through the dash.

 

[Dustins94toy]

I would really like to see the pics!!

 

[GRM]

I snapped some photos. Please excuse the mess, I'm in the process of swapping all the parts from the '85 over to the '86.

 

[GRM]

Gauges through the dash. Its pretty easy to use this same idea on 89+ trucks too.

 

[Dustins94toy]

like the cb but dont want to lose the heat. Is a 94 pickup the same?

 

[pappy]

I would still like it if someone could post some pics of there interiors.

Get creative.

 

[Dustins94toy]

Ordered a piller gauge set up expensive but hope its worth it.