Front Heater... how hot?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 4, 2019
Threads
9
Messages
32
Location
Washougal WA
Heater does work and blows warm air, but it does not get overly warm or hot. Most older heaters im familiar with are either no heat or roast your ass off heat.

What should I expect?

Thanks!
 
Mine will burn your knee if it’s not blowing on the windshield.


Hot.

Clean your heater core.
 
is it an air flow issue? or a temp issue?
you can feel the hoses going into and out of the heater core to see how hot they are.
that will tell you which direction to go next
 
is it an air flow issue? or a temp issue?
you can feel the hoses going into and out of the heater core to see how hot they are.
that will tell you which direction to go next

I have good airflow and luke warm air, heat issue. Also the rear heater core warms up, but does not give off much heat.
 
is the valve opening all the way?
does your engine get hot?
the hoses should hot to the touch,
if the rear heater isn't getting warm either, sounds like a flow issue or the engine isn't getting up to temp
 
is the valve opening all the way?
does your engine get hot?
the hoses should hot to the touch,
if the rear heater isn't getting warm either, sounds like a flow issue or the engine isn't getting up to temp

Yes engine gets hot, havent touched the hoses yet. Could a dirty heater core deplete the heat flowing from engine?

Guess I need to bone up on how the thing operates. I've read a bunch of the threads.

So engine warms, anti warms, flows through heater core and when you turn on heated air, it is warmed by passing around core? That sum it up?
 
what year rig? there will be some sort of switching valve to stop the flow of hot water in the summer, either pull cable valve or manual twist valve.
depends on what year rig you have.
the valve controls flow to both the front and rear heater, so if both aren't getting warm then it is most likely a flow issue to both.
unless both front and rear heater cores are plugged internally
 
what year rig? there will be some sort of switching valve to stop the flow of hot water in the summer, either pull cable valve or manual twist valve.
depends on what year rig you have.
the valve controls flow to both the front and rear heater, so if both aren't getting warm then it is most likely a flow issue to both.
unless both front and rear heater cores are plugged internally

'77
 
Do you have one of these, mounted on the firewall, just above where the heater hoses go into the cab?
1911291
 
Heater does work and blows warm air, but it does not get overly warm or hot. Most older heaters I'm familiar with are either no heat or roast your ass off heat.

What should I expect?

Thanks!

With a SBC, the front heater will just about burn exposed skin... the pipes to the rear will melt household pipe insulation, and the rear heater will melt kids "rubber" boots that are resting against it. It could be clogged up internally or the foam from inside the heater.
 
The original design is also very prone to gather all the junk that can be blown through the heater core. As the air flow travels down, past the heater core before being distributed to the vents.
 
Tubes going into heater are very hot, so I'm losing it somewhere after that... could debris simply reduce heat or is a blockage likely?
 
Back
Top Bottom