Found Local Machine Shop for 2nd Groove Birf Mod (1 Viewer)

[Dissent]

I just wanted to pass on a solid local business that took care of my 2nd c-clip groove machining on my birfs for the part time mod moving to Aisin locking hubs. He doesn't do much local or walk in work, most of his work comes from accounts in Ohio but he was referred to me by @Spamcheese, having done his birf prior. He charged me $40 to cut both birfs and another $25 to press a new bearing on the Lokka Spool and I had the finished parts in hand 24 hours later. Be sure to bring the correct measurements. I provided a link to the machining measurements in the post below if you don't have it already.

Wayne is a fellow wheeler and was very open and friendly when I mentioned telling other folks about him if they needed this mod done. Check it out.

Wayne Turner
Turner Engineering
3415 S 43rd Ave
Phoenix, AZ 85009
(602) 272-6014
wayne@turnereng-az.com
Turner Engineering - Home

Birf Cut Measurements, Post #11 - Aisin manual hub issue

 

[Spamcheese]

Thanks for adding him on here. His assistance was great!