Engine temps -- when to succumb to the panic?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Bludozer

SILVER Star
Joined
Mar 11, 2016
Threads
47
Messages
2,191
Location
Central Virginia
Last year around this time driving temps were in the 186-190 degree range and temps idling at stop lights were in the 190-194 range. This year I seem to be driving around in the 194-196 range and idling at 197-202. I realize severe panic should occur around 220 but in your opinion is it time for a cooling system refresh given these temp differences?

My radiator looks relatively new but I have no way of confirming if it has ever been replaced. Should I start with a new fan clutch? Replace the radiator anyway? Leave it alone and stop OCDing?

Thanks
 
Coolant flush if you haven't recently, then drain/fill your fan clutch with fresh juice of a higher viscosity. I'd do that first and then mess with the radiator only if that doen't do the trick. The viscous fluid in the fan clutch breaks down over time and most of our fans aren't working nearly as well as they did when new. Changing out the fluid is just a few bucks compared to a new clutch and will probably make a good difference.
 
Coolant flush if you haven't recently, then drain/fill your fan clutch with fresh juice of a higher viscosity. I'd do that first and then mess with the radiator only if that doen't do the trick. The viscous fluid in the fan clutch breaks down over time and most of our fans aren't working nearly as well as they did when new. Changing out the fluid is just a few bucks compared to a new clutch and will probably make a good difference.
Did a coolant flush about 6 months ago but appreciate the advice on the clutch fluid.

Thanks!
 
It's been 100+ here and with my completely overhauled cooling system and black hub fan clutch loaded with 10k CST oil, I get to 200-205 driving around town with AC on. Anytime the engine loads are reduced mine cools down a bit. It's a bit strange but many have reported and I concur , that running at highway speeds is where temps climb on hot days. When I move over to the right lane and slow down, temps drop.

If I were you, I would test the fan clutch. If it functions properly put 20-30k cst oil in it if it's the blue hub clutch which it should be based on your signiature of 1995.

An Aisin FCT-004 can be purchased at a reasonable price on Amazon.
 
Last edited:
It's been 100+ here and with my completely overhauled cooling system and black hub fan clutch loaded with 10k CST oil, I get to 200-205 driving around town with AC on. Anytime the engine loads are reduced mine cools down a bit. It's a bit strange but many have reported and I concur , that running at highway speeds is where temps climb on hot days. When I move over to the right lane and slow down, temps drop.

If I were you, I would test the fan clutch. If it functions properly put 20-30k cst oil in it if it's the blue hub clutch which it should be based on your signiature of 1995.

An Aisin FCT-004 can be purchased at a reasonable price on Amazon.
Appreciate the advice. Leaning towards the Land Tank modified one but an aisin clutch off amazon is like 1/4 the price...

Seen that, don't have a supercharger but looking at the modified blue hub.
 
The clutch is easy to mod. I've read where people put up to 30kcst oil in the blue hub clutch. It has half the oil shearing area of the older black hub line my 93 has.

I put 10k in mine and set the thermostat on it to crack open at about 100F and I still go over 200 pretty easily on hot days. I have a second fan clutch in my shop and a bottle of 15k oil on the way.

@Tools R Us advised me that, the heavier the viscosity of the oil, the harder the fan clutch is on our stock Toyota belts which are apparently pure rubber and that there are better belts on the market to handle the heavier loads applied by a modded fan clutch.
 
I don't think so. Why would they do that? What I see is that they re-proportioned the shearing areas.
Why? I don't know. A photo I saw appears to have substantially less shearing area. Why would oil ofntwice the viscosity be needed otherwise. School us.
 
there are 2 shearing areas in the clutches. The ringed one facing forward and the outer edge of the disk with the diagonal grooves. While the black clutch has more forward facing rings the blue clutch has larger flat spots on that outer edge creating more shearing surface there.

There is also a mechanical advantage to shearing on the outer edge over shearing near the center.

And everyone is raising the oil CST in these things. Even Toyota has released different clutches with different oil for towing applications.

No doubt that the blue clutch out of the box is a bit wimpy. But people are upping the CST and bending the bimetal springs on the black hubs so I don't see much of a difference.
 
there are 2 shearing areas in the clutches. The ringed one facing forward and the outer edge of the disk with the diagonal grooves. While the black clutch has more forward facing rings the blue clutch has larger flat spots on that outer edge creating more shearing surface there.

There is also a mechanical advantage to shearing on the outer edge over shearing near the center.

And everyone is raising the oil CST in these things. Even Toyota has released different clutches with different oil for towing applications.

No doubt that the blue clutch out of the box is a bit wimpy. But people are upping the CST and bending the bimetal springs on the black hubs so I don't see much of a difference.
Why, then, is much higher viscosity oil used in the blue hub clutch? What is your recommended max cst to be used in my black hub clutch? What about using the internal screw for adjusting open up temp?
 
I use 15,000 cst, so does Toyota apparently as there is a part number for it.

Black hub clutches have all since failed here in New England with our caustic environment. So I don't have any real hands on with them.

But it appears you have to selectively choose the oil CST based on your location. And I'm pretty sure higher CSTs than 15,000 is regularly used.
 
I'm on the list for an orange clutch and will be selling my blue once it comes in. If interested let me know ;)
 
So if I have the Aisin FCT-004 is this considered the blue, black, orange, or pink clutch? :) I have 10k oil in mine and regularly see 188-195 while idling on days in the low to mid 80s with the AC on. After highway driving or going up the hills to my house it will hit 197-200 sometimes. Been thinking about bumping the oil up to 20k or 30k but reading that it puts extra stress on the belts and I'm guessing maybe the water pump?

This was my intake and running temp today while sitting in line at Costco to get gas with AC on. I'm thinking I may get my dorkel soon...
20170719_141332.webp
 
Back
Top Bottom