Doors unlock when cornering?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 10, 2015
Threads
21
Messages
129
Location
New Hampshire
I've searched, but couldn't find anything like this, I'm not sure how long its been doing this, but when I take a corner (not too sharp) the automatic door locks unlock, seems to do it if I hit a good bump in the road as well (in NH that's almost all roads), but if the doors are unlocked it won't trigger them to lock. Doors lock as they should when I start the car.

I have also noticed that if I hit a bump the center dome light comes on briefly, not sure if this is related. All doors seem to close properly, I don't get a "door open" indicator on the dash.
 
The first thing I would check would be the master door lock switch, on the master switch panel, on the driver's door. It sounds like it's making contact (unlocking) when disturbed (bumped, vibrated, etc.). For all four doors to unlock at the same time, that's were I'd start checking. There are interior light switches on the two front door jams (one on each) that turn the light on and off, and I'm not sure if the two (door locks and interior lights) are connected in some way electrically. I need tutoring on that myself. If they're not, I'd check those two switches.
 
Last edited:
I was thinking that, but wanted to see what others thought, I'm not the best at wiring. Thanks!
 
Does your vehicle have an alarm? If yes, is it factory or aftermarket. The reason, I'm saying this is that most added alarm systems or keyless entry tap to the door lock wires. You may be having a loose connection hence the door unlocks when cornering. It is usually triggered when (-) ground is introduced to the wire. The wiring maybe rubbing against bare metal when cornering.
 
I have a factory alarm, I think (the remote has a Toyota symbol on it), where would I find the wires to check?
 
From what I recall in mine, the factory alarm is installed under the drivers seat. If you follow that harness it would lead you to the driver's kickpanel where most of the wiring taps occur, I would shake those wires to see if it replicates your problem. Visually check if you have any bare wires, meaning the insulation maybe ripped or damaged. You could tug on the wires a bit to make sure the connections are solid. Start from there.
 
Thanks! Now if temps get above freezing here I can spend some time checking it out!
 
Mine was doing this because the driver side door sensor was really sensitive and if the door moved like a millimeter it would unlock all the doors. I put a few pieces of duck tape on the door where it hits the sensor to make the sensor really compress and now it never does that.
 
Yeah check and see if the interior dome light comes on when it happens. Might need an LED panel as the incandescent seemed to mask it in my truck. But when I switched all the lights to LED it became very noticeable. Actually the first time it happened I thought someone was taking pics of the truck with a flash. Lol. Just needed a tiny adjustment to the latch.
 
Your 'cruiser doesn't like you and wants you to fall out when you go around a corner?
Seriously.... the dome light coming on should mean that one door is loose enough when closed to trigger the door-open/dome light switch when you get body flex or vibration. Maybe just a striker adjustment? Finding the offending door shouldn't be too hard either, just push each door in turn from the inside to see if any of them can be moved enough to turn on the dome light.
 
You can't lock your keys in your truck. That's by design.

Try to start your truck, then open the door and hit the lock switch. All the doors will automatically unlock themselves.

Fix your flashing dome light and your other problem will likely go away.


I carry a spare key as that's the only way you can lock the door with it running.
 
The first thing I would check would be the master door lock switch, on the master switch panel, on the driver's door. It sounds like it's making contact (unlocking) when disturbed (bumped, vibrated, etc.). For all four doors to unlock at the same time, that's were I'd start checking. There are center interior light switches on the two front door jams (one on each) that turn the light on and off, and I'm not sure if the two (door locks and center interior light) are connected in some way electrically. I need tutoring on that myself. If they're not, I'd check those two switches.

Wayne, How would I check "master door lock switch, on the master switch panel, on the driver's door"? Recently my power door locks and windows "went out" along with my 1st row chairs. Today, when I replace the fuse the doors and windows and it immediately shorted. The security system still seems to work though.

Do you (or anyone on this forum) have the any information (wiring diagrams, how to open and check) the entire door panel that controls the windows and door locks?

Do you know if/how the 1st row chairs could be related to this fuse and/or the driver's door panel?
 
CheleyRup, I'm at work and my EWD is at home, so I'm of no use to you at this point. Hopefully, some of the other members will help you troubleshoot this issue.
 
Last edited:
Alex, another thing to look at, I had a passenger door that would unlock as yours does, and a micro second after that would unlock the rest of the locks would unlock as well, always when cornering or going over a bump. It eventually got bad enough that the passenger door would physically open while making a left turn as the locks were doing their "Ghost" thing. My wife was convinced I bought a truck that would kick her out....

The culprit was the passenger door latch mechanism. I played with lubricating and trying to adjust it, it never really changed. I traded out the whole mechanism from another Mudder who was selling the part, took only a few minutes and the whole problem is now gone. Stays latched and the locking events haven't recurred in over 1000 miles.

Something to check. If it isn't completely latched, and it's impossible to tell, cause it's 95 percent latched, it triggers the unlock all feature because it thinks that someone just opened a door and that the locks should unlock...

Take a look or just replace the latch on the door that is suspect.
 
Most alarm systems that work with central locking often have a link to the ignition switch. Mine is aftermarket, when the ignition is switched off the doors unlock. The fact that the interior light flickers tells me the loom may be damaged between drivers door and frame?



What a great opportunity to save divorce court proceedings!

"Er, I was turning left your honour when my wife's door flew open and she fell out, this is the second time this week."

regards

Dave
 
I am curious as to any "fixes" for this problem as I have the exact same thing.
 
CheleyRup, I'm at work and my EWD is at home, so I'm of no use to you at this point. Hopefully, some of the other members will help you troubleshoot this issue.

No other inputs, yet ;) Thank you for your reply though! When I can, I'll keep digging here.

What a EWD? I have a Nissan Z car and have its tech manual with everything down to its gnat's booty. Having the Nissan tech manual has been so helpful! I can't seem to find one for this 1995 LC though. Is there one? If so, where can I get one - do you know?
 
Back
Top Bottom