distributor gear DESTORYED!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I have heard about this issue too many time to count. I really dont see why people risk it. Even swapping the gear does not ensure it wont come loose and spin, break or blow the motor from lack of oil. I have heard of it happenning with store bought DUIs and homemade DUIs but I have never heard of it hapenning with a stock dist.

This could not have done any good for your cam. Drain the oil and hope you find some big chunks of metal. Replace your dist with an OEM or a performance OEM.
 
dd113 said:
I have heard about this issue too many time to count. I really dont see why people risk it. Even swapping the gear does not ensure it wont come loose and spin, break or blow the motor from lack of oil. I have heard of it happenning with store bought DUIs and homemade DUIs but I have never heard of it hapenning with a stock dist.

This could not have done any good for your cam. Drain the oil and hope you find some big chunks of metal. Replace your dist with an OEM or a performance OEM.

WORD!
 
I've got an HEI in my 2F, and have been nothing but pleased with it. Swapped the gears with a Toy gear with a SOLID PIN.

I used to snap dizzy pins about once a month. Just couldn't keep them in. Finally started comparing my distributor (rebuilt factory at the time) with stock ones out of junked engines. From the factory, they had a solid pin. Cut down a drill bit (I forget the size exactly), tack it in place, clean it up, and you should be good to go. Gear wear is exactly like on a factory distributor.

Plus, with the HEI, you can play with the curves a bit. Most parts places carry a kit to recurve them, and it lets me play with how I want it. Right now, the lightest springs in the kit seem to give the best power.
 
anther problem you might have if your using a converted gm unit is that it may not be the correct depth. on a "big cap" the pin hole needs to be drilled into the bottom of the teeth of the gear. if your only engaging 1/2 of the gear it will be much easier for the teeth to skip or break. I would find a stock dist and compare the depth of the gear on the dist shaft
 
I typed the same thing......then didn't post it.........figured why beat a dead horse....folks just don't seem to get the picture.

sticking GM s*** in your Cruiser motor........it just don't make sense :D

dd113 said:
I have heard about this issue too many time to count. I really dont see why people risk it. Even swapping the gear does not ensure it wont come loose and spin, break or blow the motor from lack of oil. I have heard of it happenning with store bought DUIs and homemade DUIs but I have never heard of it hapenning with a stock dist.

This could not have done any good for your cam. Drain the oil and hope you find some big chunks of metal. Replace your dist with an OEM or a performance OEM.
 
Yeah, Thats why I bought mine tuned and rebuilt specifically for the cruiser. Other than stupid fawking mechanic who put it in ( oopps that was me!) I have had no problems. John is probably right that a big cap 81 would be the best choice. I bought mine used from someone who was doing a v8 conversion. I checked the part number to ensure it was the rebuilt one and even got it in the original box.
 
Back
Top Bottom