Crack in t-case - ideas?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 25, 2013
Threads
120
Messages
1,293
Location
Gilbert, AZ.
Pic below is of the t-case drain hole on my '92.

Any thoughts to fix this without having to replace the t-case entirely? Can this be welded? FIPG didn't do the trick...

Thx in advance.....

upload_2017-4-2_15-48-2.webp
 
The case is aluminum so you will need a TIG welder to do it but they can be welded on.

You could also grind a very small V out along the crack, clean it really good and JB weld it up. Grinding makes a bigger hole but also give the JB weld more area to bond too.

Either way you have to go up the side and on the sealing surface. Be careful when finishing to make sure you get it nice and flat again.

Get a new copper gasket for your plug before putting back together and don't over tighten it.
 
JB Weld and FIPG did fine for many months. I eventually had the crack TIG welded and zero problems since.
 
JB Weld and FIPG did fine for many months. I eventually had the crack TIG welded and zero problems since.

Thx! Will ask around to see who can help with the work, nothing I can tackle myself.
 
Thx everyone. @Tools R Us and I are chatting offline....
 
Back
Top Bottom