COOLING SYS ANOMALY!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I understand I need to find the leak. I'm asking if you know any particular way to find this said leak on the plastic piece you mentioned...that only leaks under temp and pressure.

Jeepers man, pressure test it with a 'pressure tester' & you will find your leak. Post 3, post 14 & post 17.
 
Jeepers man, pressure test it with a 'pressure tester' & you will find your leak. Post 3, post 14 & post 17.
Delving into the Mud archives is a double edged sword...
 
I discovered a small leak in my radiator in a parking lot. It only occurred after driving it up to temperature. At home, I'd just park it and the next morning the small leak puddle had evaporated. It didn't leak on short trips or immediately so I didn't suspect one.

But once you have a leak it can only get bigger. I patched my radiator with fiberglass and epoxy which held for a while. Then I replaced the radiator.

To find it you can pressure test it as advised in response #3 above or drive it for half an hour and park it over a clean surface and wait.

Find and stop the leak. Flush. Add new coolant and have a merry Christmas.
 
Mud OCD will get you. My PHH needed to be tightened yesterday after I noticed a small leak and I was convinced my hg was leaking near the egr. After posting my concerns I came to my senses and realized I should have put a better clamps on the phh when I changed it last year. IlI' give you some advice .My 94 would run hot on any incline, on the highway on hot days, in a head wind etc ... I finally said screw it after tinkering with it and pulled the rad, water pump, thermostat, all hoses, heater valve, and fan clutch. I flushed the engine until clean. Replaced everything and put 15k oil in the fan clutch. Topped it off with Asian red coolant and honestly it was the best $500 I ever spent. Now I have no worries and it runs cool. Now choice of radiator is where it can get pricey. Basically go with metal tanks for more money and longer life, or plastic tank radiator that cools great but may only last 5 years for cheap. But piece of mind is well worth it
 
Now you need a Scangauge or and Ultragauge so you can make sure what the coolant temp is. Read up on the dash temp gauge.

It's not OCD, it's knowing your vehicle and how to take care of it and you.
 
an OBD-II reader (like Scangauge or Ultrgauge) will not work on the '94 OBD-I truck the original poster has

use the pressure test Kevin posted about in post #3
 
Maybe because EVERY 93 and 94 LC I have seen HAVE the metal tank radiators?
And MOST folks here show a metal tank radiator when it's a 93 or 94?

Is that what you are saying or are you referring to AVAILABILITY?

Not saying it didn't happen, but did EVERYONE upgrade the radiator in their 93 and 94 LC's from the plastic tank units?

The trucks I have seen this way have verified histories with family lineage back to original.

I want to make sure I understand your rant and I will make sure I don't re-post crap, but I want to understand the idiosyncrasies of what you're stating.

Maybe THIS has something to do with it...
Not EVERYONE is a Beno.......
View attachment 1851502

View attachment 1851503

Those illustrations do not depict a 1FZ 80. They are actually a 3FE FJ62 that did have metal tanks. ANY 80 radiator you see with metal tanks is an aftermarket replacement.
 
Back
Top Bottom