clutch alignment - no tool

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 2, 2007
Threads
373
Messages
4,438
Location
Longmont, CO
i couldn't get an alignment tool for my clutch job (3b), so i'm going to attempt putting everything back in without it.

i've never done a clutch before, does everything have to be aligned *perfectly*, or can i eyeball it and let the shaft nudge everything where it needs to be?

if need be, i can turn down some aluminum round to the right size get the radial alignment perfectish, but i can't make my own splines, so the spline alignment will still be eyeballed.

thoughts? tips?
 
Just find something close enough to hold it like a broomstick or something. I've never used an aligning tool on any clutch replacement I've ever done and it's always worked out fine. A little shimmying of the tranny when you're matching it up and it should work it's way in.
 
heres the one i made .the handle diameter was a tight fit in the spline.just turned the end down to match the pilot bearing. :cheers: a little rough looking now .
IMG_0088 [800x600] [640x480].webp
IMG_0089 [640x480].webp
 
A kit with the 3 or so most common sizes is like $8 at Harbor Freight. To me that is a bargain when you are lying on your back in a gravel driveway in the dark in the rain by yourself sweating or freezing your tail off wondering why it won't fit together. There is a proper tool for the job and they are cheap.
 
Back
Top Bottom