car won't start, doesn't even click

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 26, 2015
Threads
30
Messages
200
Can someone help me debug this issue?
Car doesn't start, starter doesn't even engage.

I installed stereo I tested before putting on the face plate and it was working, however after putting everything together car is not working.
 
Check your fusible link at the battery and also check your battery cables for good connection. Lastly try to jump it.
 
Check out the Emergency Troubleshooting Procedures in the FAQ - it talks you through step by step what to do.
 
Can someone help me debug this issue? Car doesn't start, starter doesn't even engage.
What make/model of car? I had an issue with my 2002 Chevy Blazer that was 'dead in the water'. Turned the key, nada, zippo, nothing. Battery was good, radio/lights all worked. Turned out the gear shift selector wasn't fully in Park, even though the indicator showed 'P'. Moved the lever back/forth, slammed it into 'P', twisted the key... Start/Run/Gone...
 
What make/model of car? I had an issue with my 2002 Chevy Blazer that was 'dead in the water'. Turned the key, nada, zippo, nothing. Battery was good, radio/lights all worked. Turned out the gear shift selector wasn't fully in Park, even though the indicator showed 'P'. Moved the lever back/forth, slammed it into 'P', twisted the key... Start/Run/Gone...
It's Lexus lx450, actually my gear shifter is stuck as well. In on position I can't shift gear.
 
Probably won't start without the gear selector in 'P'. You're going to have to figure a way to get it into 'P' so the safety switch isn't telling the computer not to energize the starter.
 
If it won't go into park try getting the vehicle into neutral.
 
@wisemonkey have you checked the fusible link at the battery? You may not have power due to this. If your key is turned and the cab lights and dash lights etc..work and your foot is on the brake you should be able to move the shift lever. If not your fuse for the shift interlock may be blown. Your neutral safety switch circuit may also be the culprit of the no start. You can check that by moving the lever to neutral once you're able and try starting then. I'm thinking your fusible link was probably on the way out and the new stereo install may have forced it to give up the ghost.
 
Here is a link (I hope I identified them correctly). I can't judge if it's blown. So current symptoms: Gear shifter doesn't shift (I popped up small latch above gear shifter and if I poke a swrewdriver through there then I can shift) and car doesn't start at all.

I guess I'll work on it in the morning now. Appreciate all help.

Thanks
 
There are 3 fuses associated with the shift lock mechanism:
15 amp CIG
15 amp ECU-IG
10 amp STOP
All are located in the fuse panel by the driver's left knee and the CIG fuse also powers the RADIO.
Check fuses with a meter, not eyeballs.
Check fusible links with a meter, not eyeballs.
 
Just tested fusible links and all small fuses (upto 20A, don't know how to test bigger fuses). All of them look good (pass continuity test on DMM).

I'm not sure where / what is neutral safety switch, I'll read bit more from Emergency Troubleshooting Procedures - FAQ Item (Recommend Keeping Copy in Truck) (and related threads and try to see if I can find out about NSS). I'm thinking and hoping this is the issue since I can't use my gear shifter at all unless I use screwdriver trick.

If anyone has pictures showing what exactly I'm looking for that would be very helpful.

Thanks
 
Did you mess with the alarm wires while you were in the dash? I installed an amp last week and unplugged the alarm box under the driver seat and my car would not start at all. Lights would come on but when I would turn the key...nothing...no clicks or anything. I plugged it back in and cranked right up.
There are alarm wires that run close to the radio so maybe you didn't get them plugged back in before putting the dash stuff back in??
 
Did you mess with the alarm wires while you were in the dash? I installed an amp last week and unplugged the alarm box under the driver seat and my car would not start at all. Lights would come on but when I would turn the key...nothing...no clicks or anything. I plugged it back in and cranked right up.
There are alarm wires that run close to the radio so maybe you didn't get them plugged back in before putting the dash stuff back in??
This is very well possible (though I didn't know this car has alarm system, I keep seeing anti-theft written though). I'll try to disconnect all connections in dash and reconnect them to see if that helps. Thanks
 
I removed all connections from Dash (only security is intact and back seat fan -- I couldn't disconnect this)
photo_2016-11-13_10-56-45.webp


Still no luck with starting car.
The white wire wrap is I suppose some sort of sensor (mostly temperature), if not please let me know what is it.
photo_2016-11-13_10-57-02.webp
 
Take your fusible link off the battery and unplug and disconnect it from everything else. Then perform a continuity test on each lead. Move the wire you're testing around a bit and see if you lose continuity of if it changes at all. If it tests out fine I want to try something for the sake of trying it. Disconnect the alternator and see if anything changes.

Also. Do you have power to the radio and heater etc..? Or is the whole cab dead? You may need to remove the column cover and knee panel and check that your ignition wiring harness is intact also. You may try making a Hotwire rig to see if you have a failed ignition switch.

As @jonheld said there are only 3 fuses responsible for the shift interlock. But there are also a couple switches, one of which is the ignition and another the brake switch.
 
Take your fusible link off the battery and unplug and disconnect it from everything else. Then perform a continuity test on each lead. Move the wire you're testing around a bit and see if you lose continuity of if it changes at all. If it tests out fine I want to try something for the sake of trying it. Disconnect the alternator and see if anything changes.

Also. Do you have power to the radio and heater etc..? Or is the whole cab dead?
Power to radio, heater, horn, headlights, hazard lights/ blinkers is all good. Whenever I turn key to start position it feels like there is no connection at all.

I'll try checking fusible links after isolating them.
Thanks
 
Back
Top Bottom