Ball Joint or CV Joint?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 9, 2004
Threads
51
Messages
291
Location
Southern New Jersey
In what year did Toyota switch over from the ball joint front axle to the birfield CV joint? I have a haynes manual that I have been reading and it says both joints were used on the 40 series, but it doesn't say which years came with which joint.

Are the ball joints inferior to the CV joint? I would imagine so by looking at the picture diagrams.
 
That's a good question. Why did they elect to go with a birfield rather than a universal?
 
related question: is the spline count on the inner shaft the same for the Ball-and-claw and the Birfields? In other words, could one swap one complete set-up for the other?
 
DSRTRDR said:
related question: is the spline count on the inner shaft the same for the Ball-and-claw and the Birfields? In other words, could one swap one complete set-up for the other?



No.


You will need to change the side gears in the diff in order to make the axles work in there....and then you will need a seal where the bronze bushing is in the older housing...


:beer:
 
Doug_S said:
That's a good question. Why did they elect to go with a birfield rather than a universal?



A CV joint (fing birfield) is a far smoother operating joint at angles under power than a u-joint....
 
Thanks for the wisdom. :beer:
 
Poser said:
No.


You will need to change the side gears in the diff in order to make the axles work in there....and then you will need a seal where the bronze bushing is in the older housing...


:beer:

this is true for the USA fj40 but there are some 68' 40 with ball and claw that got the fine spline iner shafts in NON USA markets. Rare as a hens tooth
 
Back
Top Bottom