Axle question, Hit and Run!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 8, 2006
Threads
3
Messages
48
Location
Commerce, CA
Going on the Tow truck by Mrs4x4 posted Aug 17, 20I have a 1996 LC that was hit las weekend. Was wondering if anyone has experienced anything similar and can share what the possible damages might be?

IMG_5815.webp
 
Last edited:
You are going to need to put a lot more info here. Maybe some pics. Before anyone can really offer any advice.

Where was it hit?
What is the obvious damage?
Does it run?
What was the condition inside and out before the accident?
Does it hold any sentimental value?
etc.
 
You are going to need to put a lot more info here. Maybe some pics. Before anyone can really offer any advice.

Where was it hit?
What is the obvious damage?
Does it run?
What was the condition inside and out before the accident?
Does it hold any sentimental value?
etc.

Just posted pictures. It was hit on the left rear tire. Overall vehicle is in good shape.
 
How likely is it that the whole rear axle needs to be replaced?
 
Those pictures show nothing other than impact looks isolated to the axle other than the fender.

I needed a new front. It was a grand. If you have insurance coverage, you're just out your deductible.
 
Stuff you may need to replace:

1) Axle
2) Wheel
3) Control arms

If replacing the axle, and depending on status of new axle and current one:
1) rotor (pair)
2) caliper
3) wheel bearings etc. for axle rebuild.
 
The insurance totaled the LC. Estimate was $3500 to repair.


IMG_5900.webp
 
Last edited:
Collect check, buyback, repair, insure liability only.
 
I think that is what I am going to do, because I love my rig.

Zero reason not to. Make insurance tow to your favorite LC shop for inspection to understand what you're getting into. If it's only your axle and CAs that are toast, you're looking at around 3k for a shop to do it.

Guessing here, based on my replacements:

1k axle
500 for 2x rotors, 2x calipers, 2x pads.
250 for seals bearings, diff fluid and related bull****.
1-1.5k labor.

Parts store like O'Reilys/AZ will give you core charge back on old calipers. Good current axle parts may be worth some coin too, make sure you're compensated by the shop or keep as spares.
 
Before you get too deep into it you want to make sure that the frame and control arm hangers are not bent or twisted. A shop that specializes in collision work and frame straightening can determine this but be aware that they have an incentive to make money too so make sure that they show you what is bent and why.
 
Before you get too deep into it you want to make sure that the frame and control arm hangers are not bent or twisted. A shop that specializes in collision work and frame straightening can determine this but be aware that they have an incentive to make money too so make sure that they show you what is bent and why.

Doubt the frame is bent. Mounts cost nothing to replace, and the arms seem to bend or break before the mounts. So I doubt those are bent.
 
Back
Top Bottom