Aussie in the front?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 21, 2004
Threads
73
Messages
597
Location
The Rockies or the Andes
I have an Aussie in the rear diff and love it, and was wondering about an Aussie up front. My oldest cruiser friends in San Diego told me years ago that a non-selectable locker up front is a bad idea because going downhill in 4wd the front end can take a track that you can't steer out of (it "has a mind of its own" is how they put it). So I have been planning on waiting and spending the $ on an ARB. This is a trail rig, not a DD, however I can not and do not trailer it, it is and will remain street drivable.

So, a positive locker up front should not be an issue on road in 2wd with the hubs disengaged I am assuming. Or am I wrong?

Which leaves the big question, how does it handle off road? I would love to get some input from those who have this set up. Is downhill driving a problem? Will power steering help? Will I need to disengage 1 hub or 4wd to go downhill? Should I just wait and get an ARB?

I am not trying to be cheap, but the money I could potentially save would finance other projects, like power steering!
 
You notice it a little, I've never been on much slickrock type stuff to say how it acts on a high traction surface - gravel and dirt trails it's hardly noticeable - although i do have sag PS, that may make quite a difference.

I am pretty anal about unlocking hubs and running in 2LO a lot, don't want a broken stock birf just because I forget and do something stupid
 
2 lo and a rear locker will surprise you in many sitiuations.if i were locked up front i would use 2 coming down if i knew i was gonna be in trouble on the way down.sorry for the double post.didnt read enough.
 
You don't need a second shifter to get 2 LO - just a hacksaw or grinder and about 10 minutes of your time. Really easy and usefull mod - good pics here a while back - redrustbucket did his 55 I believe
 
2-Low - remove the boot, look inside....see a L-shaped guide...turn that into a square..instant 2-low.

PS is a must with a front locker, unless you are build like popeye, or you want to be....

I've run a front EZ-lock for many many years and like it. There ARE times it binds tight, but with 35-under tires those should be pretty rare....start getting real big and you'll want hydro assist as well.

in 2wd, it acts like an open diff, same if you are in neutral. Lunch-box lockers ONLY lock when under load, either accellerating or steep downhills where you keep it in gear to help slow yourself own....hit neutral (push in the clutch) and you can mitigate most issues.
 
Magoo said:
keep in mind if you are geared like a mutha you can explode your clutch while going down hill if you just push it in.just a thought.
shawn

How is that going to explode a clutch?
 
woody said:
Lunch-box lockers ONLY lock when under load, either accellerating or steep downhills where you keep it in gear to help slow yourself own....hit neutral (push in the clutch) and you can mitigate most issues.

Woody,

This is not an accurate explanation of how they work. :o

In the forward direction, no wheel can ever rotate slower than the ring gear, load or no load in neutral. Only 1 wheel per side can ever rotate faster than the ring gear, load or no load in N. If you give it enough power so that a tire starts to slip, that tire will lock so that it never goes slower than the ring gear. Load only matters in their operation if it is enough to make a tire slip and then both sides will be "locked". Same thing is true in engine braking or down hill, just that now no tire can go faster than the ring gear and it is the outside tire the oustide tire is driving in a turn.

Because of this the front inside wheel will always under steer or push out of a turn in 4wd even with the clutch in or the tranny in N. During acceleration, the inside tire wants to go slower than the ring gear because it has a shorter radius, but it can't because it is in 4wd and the locker won't allow it to turn any slower than the ring gear.

Put it in 2wd to go down hill. The inside tire can now go any speed it wants because it is no longer coupled to the transfer case.
 
Last edited:
Hi All:

Yes, I know, slightly off-topic, but it was mentioned earlier in this thread.

Does anyone have a pic they can post of a modified (from stock to allow 2 Low) shift gate, preferably show mounted on the tranny?

Thanks!

Alan
Seattle
 
i was about to ask the same thing, any leads on a thread i could read to do a 2-lo mod
 
Back
Top Bottom