Anyone rebuilding/servicing diff lock actuators?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 2, 2014
Threads
31
Messages
206
Location
Simi Valley, CA
My rear locker isn't engaging. I verified that the motor worked when the diff lock switch is activated, but the pin doesn't move in/out. I read many threads and tried dis-assembling, cleaning and re-assembling the unit, but now id doesn't show any signs of movement when the switch is turned on/off... so basically, I made it worse :) Is there anyone on the forum who fixes/services these?
 
How? By still using the same controls?
You would have to search for a bit, there was a extensive write up on it years ago in the 80s section here. The guy was going to make a kit in the thread but I don't know what happened. But its very detailed, and not hard to duplicate. Fairly inexpensive, when I put a rear elocker 80 axle in my 40 series I did the pneumatic conversion to it. You can see a pic of it in my build thread. I even eventually wired in the factory engagement switch on the differential into a led so I know when its engaged and disengaged. I already had on board air and a arb up front. So hooking up the rear locker cost me about 100 bucks.
 
I'd rather not mess with it, or spend hours on end trying to figure it out. Anyone on the forum (who has already done this type of adjustment/service) willing to do this for a fair price?? If so, please PM me.
 
It's my rear that's bad, and that's @ $400 for a new one :( I was thinking, for someone who knows what they are doing, this should be pretty easy to fix. Mine has no corrosion or broken magnets/any other broken parts inside.
 
It's my rear that's bad, and that's @ $400 for a new one :( I was thinking, for someone who knows what they are doing, this should be pretty easy to fix. Mine has no corrosion or broken magnets/any other broken parts inside.
Same with mine. If you want it to work properly then get it replaced or you can hack it up for the same amount of money. Pick your poison.
 
The "pin" and shift fork only move when the locking collar and side gear teeth line up perfectly. You need to jack up a wheel with the transfer case in N and spin the wheel to get the teeth to align before it will click in..
 
Same with mine. If you want it to work properly then get it replaced or you can hack it up for the same amount of money. Pick your poison.


I've reworked a few of the rears now and the bill is typically 175.00. But my schedule is pretty booked and actually finding the time can take a while.
 
Back
Top Bottom