- Thread starter
- #21
my ricebilt rods showed up today...one set for piggie, one set for the 60 
another chapter in piggie's life
- Thread starter nuclearlemon
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #26
nope...denver
MiniPigg said:
Ige came to our meeting at Ben's... you missed a brush w/ greatness!!!!
- Thread starter
- #29
yes...i'll probably be riding with treeroot cause money's tight while i get the piggie going 
- Thread starter
- #30
well, all was going well until i snapped the last bolt when putting the bellhousing on
Damn.... easy muscles. 
Did you get the threaded portion out?
Did you get the threaded portion out?
nuclearlemon said:well, all was going well until i snapped the last bolt when putting the bellhousing on
DAMMIT!!!
- Thread starter
- #33
no...i didn't feel like touching it then.usmcruiser said:
Ige,
So what's going on with this now?
So what's going on with this now?
RUSH55 said:
lookin good Ige.
- Thread starter
- #38
operation wide track
originally posted this in the girls garage a little over a year ago
, but i can't keep you guys outta the loop.
the piggie's getting 60 series axles.
while i've had both axles, i had put the rear under there to keep it out of my way, sell the old axle and drool a bit.
in the meantime, i acquired another 60 rear housing for free, so i decided to clean that one up (the one under the cruiser now is literally just sitting there, i haven't even cut the old mounts off yet).
so, the last couple of weekends (had to stretch it out to two weekends because i ran out of cutoff wheels and grinding discs) i got the front housing and the extra rear housing completely cleared of all mounts and cleaned up. i mean everything came off the front and all that's left on the rear are two mounts for the ebrake cable.
here's what i started with two weekends ago...can't say i didn't get my use of the grinding wheel
originally posted this in the girls garage a little over a year ago
, but i can't keep you guys outta the loop. the piggie's getting 60 series axles.
while i've had both axles, i had put the rear under there to keep it out of my way, sell the old axle and drool a bit.
in the meantime, i acquired another 60 rear housing for free, so i decided to clean that one up (the one under the cruiser now is literally just sitting there, i haven't even cut the old mounts off yet).
so, the last couple of weekends (had to stretch it out to two weekends because i ran out of cutoff wheels and grinding discs) i got the front housing and the extra rear housing completely cleared of all mounts and cleaned up. i mean everything came off the front and all that's left on the rear are two mounts for the ebrake cable.
here's what i started with two weekends ago...can't say i didn't get my use of the grinding wheel
- Thread starter
- #39
here's where i finished the weekend before last. since it will be forever before i get around to any welding, i rattle canned them for now to keep rust at bay.
Glad to see Pig progress Ige!
PS - Your Pigs in Print post shows up in some weird MUD view...
PS - Your Pigs in Print post shows up in some weird MUD view...