Builds AK HJ-75 (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

It’s on and it clears the garage entrance by about a 1/4”

B8B1A014-6BB9-4FEE-8CCD-2383E410F0FE.jpeg


307436D6-0FA7-48DD-B375-C4B3ACC43B7A.jpeg


8CC35711-0C05-4998-84E5-98C3E2F85DA9.jpeg
 
Looks great.
Have you got any grief displaying the Australia plate from the any law enforcement? I have seen a few people on MUD keeping their imported plates visible along with their new plates.
 
Looks great.
Have you got any grief displaying the Australia plate from the any law enforcement? I have seen a few people on MUD keeping their imported plates visible along with their new plates.
I think the writing on it is so small it is hard for people to read, but no not yet.
 
Ssssshhhhh, don’t say anything, that is plug in for the electric motor. Ha... just kidding. That is the coolant and oil pan heater plug in. It normally is loose but taped it down to see if it was/is a source of strange noises, which I don’t think it is.
 
Ssssshhhhh, don’t say anything, that is plug in for the electric motor. Ha... just kidding. That is the coolant and oil pan heater plug in. It normally is loose but taped it down to see if it was/is a source of strange noises, which I don’t think it is.
For all those frigid nights in south Georgia?
 
If AC powered had been installed while I owned the Ute it most likely would have powered one of those "bug zapping" lights hanging from the roof rack. :)
 
Last edited:
The above photo is definitely "avatar" worthy.

P.M. Sent
 
Last edited:

Users who are viewing this thread

Back
Top Bottom