80 Series Brake Issue - Looking for Advice

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 1, 2022
Threads
39
Messages
100
Location
Australia
Need some advice from the 80 Series gurus.

When driving around 40-60 km/h and I hit the brakes hard, the vehicle doesn't stop as it should. The brake pedal goes almost all the way to the floor and I can still feel the Cruiser moving. However, if I pick up the speed and break hard on an empty road few times (2-3 times), 4th time onwards, the brake feels much much better.

A bit of background:
  • During a recent brake bleed, we accidentally let the reservoir run dry for a few seconds.
  • Since then, we've done a full bleed twice (including LSPV valve) using the traditional 2-person method.
  • No obvious external leaks.
Would you do another complete flush and bleed, or investigate something else first?

Thanks in advance for any suggestions. 👍🚙💨

1997 Landcruiser, 1FZFE - Auto
 
You need to pressure bleed your system, and activate your ABS while under pressure ( either driving or activating electronically.). And pressure bleed some more after that
 
I had similar symptoms but not the exact same. Mine would squish to the floor and sorta stop but not really when cold. Then when it would warm up it was fine. Then on a random day I had a rock hard brake pedal and very little brakes. Mine turned out to be the brake booster. Swapped in a new one, and my truck has never stopped so well in the 11 years I have owned it.
 
Try gravity bleeding, you said also you let the reservoir go dry sometimes bleeding at the brake lines that go to the master helps it works just like a two person bleed but do it by loosening the brake lines at the master one at a time if you see air bubbles it’s possible there was a pocket of air in the master itself. It kinda works like a bench bleeding a master. Good luck!
 
Back
Top Bottom