Good truck and seller there ^^^
100 Series General Tech and Classifieds
- Thread starter wngrog
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Good truck and seller there ^^^
- Thread starter
- #7,362
60’s on 100 chassis?
- Thread starter
- #7,366
Oops.
Finally getting around to creating a place for my golden retriever that doesn’t eat all my storage + keeps him out of my lap. We’ll see how it turns out in a few weeks.
Dustin Messina
SILVER Star
@offr0adlim0 ready to install a lift on this rig? Should clean up , ha
My eyes need a tetanus shot after looking at that pic...
- Thread starter
- #7,370
“Typical Land Cruiser Rust”
Dustin Messina
SILVER Star
This is light rust on a Craig’s list add up north I’m sure...
Warranty work?
Taco/Tundra/Sequoia frame recall.
Stupid American steel... 
J code for life!
J code for life!
Not happening. I wouldn’t put that on a 2-Post lift. You’re going to need a torch to get those bumpers off. How’s the interior?
Stupid American steel...
J code for life!
Not the steel. It was the lack of quality oversight by Dana Corp.
Just poor build quality? Not sure I ever really understood what the issue was. Bad welds? Poor prep prior to coating?
The issue was that Toyota outsourced the frame manufacture to the Dana Corp (made in US and all that jazz).
Dana Corp proceeded to forget one of the critical steps in rust proofing the frames. Hence, they were eaten up in short order.
Dana pays $25 million to Toyota to settle Tacoma claim | Reuters
Dana then declared bankruptcy around the same time as the bailouts to the automakers and Dana sold the frame manufacturing operation to it's own subsidiary in Mexico.
Which Toyota now buys the frames from. That's just the tip of the iceberg.
And, Toyota's own metal supplier's aren't the greatest either.
Kobe Steel, Toyota hit with U.S. lawsuit over vehicle metal quality | Reuters
Dustin Messina
SILVER Star
I wouldn't lift it either, but it runs great and interior is pretty dang good. I'm going to be using some of the interior in my 100 as well. Bumpers, sliders, and skids are off and all the Slee stuff held up great! Gonna get them repowder coated and roll.