valve

Today read about this on a FB Toyota Lexus page. Is there a heater diverter valve and if yes, a point of failure? Besides the infamous T's, its a mystery unable to sort online.

Would y'all consider this enough oil seepage to warrant a new gasket? I already replaced the passenger side, but left the driver side as-is bc it was so much more difficult to access the bolts and I would much rather not deal with it. this perspective is through the driver side wheel well...

Looking for Emissions air bypass bracket for 1974 1F. Item#90 in attached picture

I was testing my AC Idle up, and while it was engaging, it was not consistent or strong enough(FJ62 Manual). I then 'bypassed' the AC Idle up Valve and found plently of suction to engage the suction cap switch. I found I was loosing pressure in the AC idle up valve, and some testing found that...

Here’s a basic question: When replacing vacuum lines on the HAC valve, the book references Left/Right for the various lines. Is this when the value is viewed from the top, or if looking straight at the ports? This makes a big difference in routing the lines.

I found this in an old post by @wngrog on is 67 FJ45 build. Can anyone tell me where the shut off valve (I have the piece that goes into block all ready) and 90 degree came from please.

Hello everyone! I need help with identifying my valve body in my 100 series 5 speed diesel Landcruiser. Is there an easy way to tell if the valve body has been upgraded? Also is there any difference in shifting feel between the factory and Nomad one? Thanks!

I need to replace (or have replaced) the Main Valve to the house. The Main Gate Valve that's there won't close completely and the Curb shut off is frozen. Makes doing any kind of mild plumbing repair in the house lots 'o fun ... After I get DWP to replace the Curb Cock, I will tackle the...

...

Hey Lads, Does a 3b head 11101-58014 small valve fit on a 11101-58010 big valve block? I’ve gotten stitched up with my new head and now probably is a expensive paper weight. Cheers!

Hi all, I’m getting close to putting my ‘77 CA spec FJ40 together and have to eventually smog the car. I’d like to understand what are the differences between EGR valves between the different years, or even within the same year. My questions are only about the EGR valve, not the cooler, pipe to...

Just below the heater control valve on the firewall. Its pretty soft and its pretty obviously leaking. I can't find what it is PN wise or dimension wise.

Anyone know where to get just the O-ring for the spill control valve? If not I can just get the whole seal kit! I'm not having any fuel delivery issues indicative of a bad one, it's just noticeably leaking from the top of the rubber grommet.

Hi folks, I have a 65 FJ 40 with the heater removed. I have this valve and attached hoses Under the center of the dash. Can anyone identify and explain how this works? I want to install a heater and assume this valve and hoses will be part of the project. Grateful for any guidance here. JB

I was working on bleeding my brakes yesterday and noticed that when my daughter was pushing on the brakes that brake fluid was spraying out where the brake line mates to the proportioning valve? Will a bad proportioning valve do that. The flare on the brake line looks ok to me. Any advice would...

I broke my HACV formy 82 fj60. Looking for a functioning replacement. looks like it can come off an 80-87 2f fj60. 25709-61010 Valve Sub-Assy, High Altitude Compensator HIGH ALTITUDE COMPENSATOR [08.1980 - 08.1987]2F..FJ60..USA Price shipped to 78660?

I was swapping my old vacuum lines for fresh and snapped one of the plastic nipples off what I think is my HACV, high altitude compensator valve. I checked on mega zip to Id it, pretty sure it's th HACV, and it shows discontinued. US there a later valve I can replace it with?or am I down to...

2F valve cover $75 plus the ride

Hi. Im looking for 4 valve cover studs. Putting together my basket case fj60 and those studs are missing. If anyone has some, please let me know

2004, 370k miles. I just purchased it this Spring and have caught it up on all maintenance and repairs. Truck seemed well taken care of, no leaks, no smoke on start up, does not use oil, etc…. A little background, I have done all fluids, filters, Denso plugs and all 8 coils, new O2 upstream...