troubleshooting

  1. makaishj75

    Need help badly, Glow plugs not working

    Hey All, I’m a 17yr old with no clue on a lot of stuff but am trying to learn, I have a 1989 hj75 with a 2H and my car has had a lot of trouble starting, putting out big white clouds (assuming unburnt diesel) so I have concluded it’s the glow plugs. After looking under the hood at the buzz bar...
  2. H

    Solved: intermittend Check Engine Light ... code unobtainable

    97 FZJ 80, European spec., delivered to Finland, no OBD2, 1FZ with 360 000 km on the clock. for the last 2000 km (starting in the dunes of Grand Erg Oriental/Sahara desert) the CEL came on intermittendly. When trying to get a code with the paperclip method: continuous blinking and after...
  3. A

    TC lockup troubleshooting KZJ78/A343F

    I’ve been chasing an intermittent issue with lockup not engaging at highway speeds. I know there are general conditions that the ECU needs to see to enable lockup such as speed, oil and and ATF temperature, but maybe 50% of the time lockup does not happen when these appear to be met. When...
  4. Groucho263

    Birfield Going Bad?

    Hey guys, Need help troubleshooting the left front while in 4 wheel drive. When in 2 wheel drive and hubs not locked, it drives and turns with no problems. Hubs locked and in 4L, it goes forward and reverse no problem as long as the wheel is straight. Turn the wheel and get a clunking noise...
  5. M

    Code remains after new O2 sensor

    Got P0037 code and replaced both downstream O2 sensors with Denso. Code came back on and took to my local shop but they were unable to diagnose and suggested going to dealer who may have better diagnostics. Any ideas before trying to navigate stealership nightmare?
  6. B

    No charging - occationally

    I have a LC 100 99 model with 450 000 km. Last week I started to experience problem with charging - for several hours - no charging emptying batteries with no charge lamp. I bought a voltmeter for the lighter port to closely monitor the voltage as my garasje have not been able to fic it...
  7. MatthewMcD

    Brake Master Cylinder and Booster Troubleshooting

    I recently replaced my rear drum brakes on my '75 FJ40. The front has disks and the PO recently had new shoes fitted. After flushing the whole system I kept it on the jack stands and ran the engine in 2WD. The wheels turn, but the brake pedal goes straight to the floor. Looking at the master...
  8. AJLaz

    Low Pressure AHC Pump Troubleshooting Help Requested

    Greetings fellow enthusiasts, Things have begun to go south on my '10 LX with ~95k Miles. A few weeks back I flushed my AHC with 0 initial problems, I followed the guides posted here including using the Metal can AHC Oil and I bled multiple times until the fluid from bleeders was perfectly...
  9. CharlieS

    Fuel Pump Relay Troubleshooting

    Hi All, Could I get a sanity check on normal behavior of the fuel pump relay (FPR). I'm trying to determine if I should be observing cycling of the FPR back and forth during engine warmup. By observing, I mean hear it clicking and feel the relay cycle periodically by putting my hand on it...
  10. PAToyota

    Air Conditioner / Furnace Troubleshooting

    So, yesterday I went to turn on the A/C (whole house - turned on from thermostat) and just heard a buzzing from the basement. Turned it back off and went down to take a look. Checked the fuse and then pulled the covers off the furnace to take a look at anything. Nothing seemed out of order and...
  11. CHILLCAT

    HJ61 - Can I remove AC belt & run without harm?

    I am trying to chase down a new noise under the hood. Its a sort of "swish" sound that may be either bearing or clutch related on the AC compressor. It cropped up at the end of a long road trip recently. As far as I can tell its coming from the AC compressor pully area. Can I remove the AC Belt...
  12. CharlieS

    Air locker troubleshooting?

    Anyone have guidance or a link for air locker troubleshooting? I finally got my new to me 80 out on trail and got myself hung on an obstacle where my locked front should have pulled me through. My friend said the front wasn't turning despite being fully locked according to switches and...
  13. drowzyGX

    Auxbeam switch troubleshooting

    Hey Y’all, My auxbeam switch stopped working recently, and I’m having some difficulty with troubleshooting. Below is a picture of the switch and information on voltage readings taken with my multimeter. Any thoughts on what might be the issue are greatly appreciated. All voltage...
  14. patiofurn

    Anyone have experience bleeding brakes and troubleshooting on a 80 series?

    Hi All, I just took delivery of a 97 LX450. The previous owner had replaced the brake booster and wasn't happy with the job the shop had done (not a Toyota specific shop). I knew that I'd have to put some time into this and I'm going to be working on it this afternoon and tomorrow. Does anyone...
  15. F

    Odd starting problem

    Hello wise FJ lovers, I would like your help diagnosing some strange problems with my 1976 FJ40 Here they are: When first turning over, the starter spins slower, then gets faster the longer it spins. This may take a couple 5-10 second cranks, with the starter spinning faster and faster the more...
  16. gunrule

    Hilux  1987 Toyota pickup 4wd shifter wont work truck wont move

    I just picked up my Toyota 1987 extended cab SR5 22r last month and drove it from Arizona to Kentucky. I took it out hill climbing and mudding for about 5hours. Was in 4wd and 3rd gear going fast over some mud and the engines rpm was going up without me pushing on the gas and in neutral so I...
  17. T

    IH  Ignition Wiring HELP

    Picked up a beauty 69 Scout 800. Immaculate condition when I got her, body and engine. Turned the ignition one day to take her for a cruise and it rotated enough in the column to rip two wires off. Whoever did the wiring when they put the new engine in didn’t have any thing labeled as to what...
  18. Jhnpv

    ‘95 80s has an extremely rough idle. What can I do?

    Recently, my cruiser has been idling very rough. It will stay around 700 RPM, and then suddenly drop to about 200 RPM and nearly stall. Has anyone had trouble with this before? What do I do?
  19. senatedestroyer

    Lx door restoration?

    my rig: 96 lx450, 181k, I bought my 96 lx a little under a year ago. I’ve noticed over that time the windows have loosened up (rattle when not fully up, sliding out of the track about 1/8th in.). Wondering if anyone has restore these; replacing clips/brackets, updating mechanics, replacing...
  20. D

    Start up idle issue, troubleshooting

    Hi guys. I’ve continued to have trouble with my idle on start up from cold. It’s a 94 1fz fe. I’ll give a little background which may help a bit. It was running fine until one day my vaf meter door blew open and jammed, ever since then I’ve had idle issues. on first start up the idle the engine...
Back
Top Bottom