hi everyone,
are there any tips and tricks to removing the plastic cladding off the truck?
getting ready for paint and thought i'd remove the stuff myself.
thanks
Looks like I will be swapping out the alternator on my 1974 40 series. Engine shuts off when jumper cables are removed. Would appreciate any tips/suggestions as I am still learning the ropes on this machine. Searched the forums but could not find threads for an older fj on the subject...
Well I've done this twice now. The first time, I used a pvc pipe that supposedly got the right depth. The second time, I used the wits end tool. Since I have failed twice, I'm looking for tips or confirmation on my checklist before I try this again.
1. Use wits end tool to get flush mount
2. Be...
My clutch slave cylinder gave out, leaving a puddle on the floor under the passenger side. I bought a replacement master and slave cylinder since the recommendation is to replace both at the same time. I’ve been trying to get the hydraulic line off the master cylinder for the last 3 days...
The washer that's pressed into the alternator mount has popped out (Wether it's supposed to to that or not idk) and I can't get it back in to refit the alternator anyone got any tips on how to do it or is there a tool that will do it.
I have a 2004, and I want it to last a long long time. It’s my daily driver and my vacation explorer. Parts for these 100 series rigs are becoming harder to find, so I’m conscious of my rig’s maintenance needs.
Beyond routine maintenance stuff (e.g., fluids, timing, heater Ts), what are the...
I picked up a cheap 1991 80 series and I was getting around to replacing all the shocks with the Tokico ones. The fronts were easy but the rears are giving me some difficulties where it has a bit more rust.
I can't seem to get the bottom bolt out and I may have made it worse. A 17mm socket...
Recently bought (1 yr ago) a 2008 LC, after wanting to get an LC for a while now. I have been lurking around this forum to get some tips and thought I had better join.
Well, today was the day. I look forward to gleaning info from the more experienced people out there.
Going to tackle my last (fingers crossed) exhaust leak on my 82 FJ 40 - Saudi Spec…any top tips for replacing these gaskets on the downpipe? I’ve read a thread about failures around the flange so I’ll have a look for any cracks. Any other tips are very welcome! Cheers
I just replaced the transfer case shift lever seat in my '93 4WD 4-Runner with the manual transmission. I'm having a lot of trouble holding down the metal cover against the force of the spring so I can install the retainer clip. Are there any tips and/or special tools that will make this easier?
Good day guys its been a while since I have las posted but have done a really nice upgrade to my 2017 LC 200.
I had a AFN fron bumper and warn winch installed.
Since that upgrade what was a squeak noise free rig is now like a rusty old machine the bumper rattles allot and you can hear it...
Any tips. This is getting really annoying. Easier to have transfer case in 2wd or 4wd? Do you push up on end of axle or push down? Should I not have put the knuckle on first? Can't get this thing in there been trying for over an hour.
EDIT: Finally got it. For anyone else reading and having...