Good evening fellow land cruiser enthusiasts,
I have designed, now almost 2 years ago, an electronic replacement for the "superglow timer module" that failed on my BJ42 (3B engine). It is a direct replacement for 9pin modules (28521-57010).
I shared the development issues and success on this forum (Superglow electronic replacement - https://forum.ih8mud.com/threads/superglow-electronic-replacement.1323121/) and eventually proposed to sell some boards. There was reasonable demand and I ordered components and PCB to make 20 boards.
During those past two years I also had many demands about the 13 pin version (28521-57051). My original design is compliant with the functionality (rewire possible to 9 pin connector which is provided along with the board) but I also took some time to make a new design, 99% identical, only with a 13 pin connector.
I just sold the 19th board and got 2 demands in a row, probably due to winter incoming, with so far no complaint about the board.
I would like the parts to remain available and I am willing to order a new batch, possibly a mix of 9 and 13 pin.
--> Therefore I would like to know if any of you would be interested in a board and if so which version.
As a reminder there is a pdf manual available for the 9pin version (User and installation manual).
Kouglof
I have designed, now almost 2 years ago, an electronic replacement for the "superglow timer module" that failed on my BJ42 (3B engine). It is a direct replacement for 9pin modules (28521-57010).
I shared the development issues and success on this forum (Superglow electronic replacement - https://forum.ih8mud.com/threads/superglow-electronic-replacement.1323121/) and eventually proposed to sell some boards. There was reasonable demand and I ordered components and PCB to make 20 boards.
During those past two years I also had many demands about the 13 pin version (28521-57051). My original design is compliant with the functionality (rewire possible to 9 pin connector which is provided along with the board) but I also took some time to make a new design, 99% identical, only with a 13 pin connector.
I just sold the 19th board and got 2 demands in a row, probably due to winter incoming, with so far no complaint about the board.
I would like the parts to remain available and I am willing to order a new batch, possibly a mix of 9 and 13 pin.
--> Therefore I would like to know if any of you would be interested in a board and if so which version.
As a reminder there is a pdf manual available for the 9pin version (User and installation manual).
Kouglof
