I've got a ton of blue smoke when I start my 75' Hj45. Stalls out and I start it again...takes a while for it to settle down and smooth out...runs fine after about 10-15 minutes.
Injectors? Fuel pump? Any suggestions on where to begin?
Hi guys, does anyone have any ideas what could be causing this on my HJ 45 diesel slow poke 3.6lt ……when it is cold first thing in the morning when I glow it for 20 seconds Then start then it runs for about 10 seconds then just stops, turn the key again runs for another 10 then stops, third...
I'm getting this 79K mile '90 LJ78 turbo diesel delivered today. There is a station in town with B30 diesel. Would using that cause any problems? This might depend on a precombustion chamber. Does this engine have that? Thank you for reading and especially a response!
Selling the aibox and rubber piping that goes down to the turbo off my hdj81. Its a 92 and the airbox is pretty rust free and hoses are in good condition. Asking 300 OBO for everything im located in Colorado USA
I'm getting this 79K mile '90 LJ78 turbo diesel delivered today. There is a station in town with B30 diesel. Would using that cause any problems? This might depend on a precombustion chamber. Does this engine have that?
As the title states, used Safari Turbo (Garrett) set-up for 1PZ/1HZ engines.
Remover after 6 years of use.
You get:
1. Turbo assembly
2. Manifold adaptor (already tapped for EGT probe)
3. Collector flange for back of turbo
4. Downpipe.
The rest to install a turbo would be...
Do you think this is a leaking turbo?
I was told to get a catch can and it should prevent this from happening. However, when I installed an Intercooler, the hose from the intake crossover pipe to the turbo had some oil residue. Thanks!
As usual, as winter turns to fall and temps drop, there's a lot of talk about diesels in the cold, especially if you are new to winter dieseling... So I thought a run down of my experiences with preheating methods might be helpful? This is borne out of 18 years of JDM diesel experience in temps...
The 14B-T is maybe my favourite B engine and during much internet trawling, I finally came up with some official-looking specs. It comes from a Taiwanese customs website, looks to be an official document for import/registration in Taiwan.
The 14B-T was mostly sold in Japan in 24V Dyna/Toyoace...
Hey Folks,
I'm researching my next build and I'm planning on a 2.8 Durax that is tuned to 220hp / 440tq. With that level of torque, I seem to not be able to find any specs on max torque of land cruise transfer cases. I was think of going with a FJ62 case converted to FJ60 shifters.
What do...
Came off a B-series engine, I think 3B but can’t remember exactly. No idea on compatiblility.
$20 plus shipping.
Can vapor hone it and make it beautiful for $20 additional
Got me a running engine for my truck ... but the block is pretty crusty ... just wanted to make sure before going too far on the rebuild that there is no oil gallery on the exhaust side of the block where circled , picture is not mine
I have 3 sets of the oem floor mat sets available for lhd 76 models , in my logic these will certainly also fit the older LJ and KZJ 77,78,79 lhd models and the front ones will fit any lhd 7x model
150$ including shipping in the lower 48 , these are the only ones I have so once these are gone...