Before I cut the bumper on my 19 Lux did some searching on the impact that it has on gas mileage and found lots of others asking the same thing. No one had ever answered the question on any of the posts, at any website. To me the answer isn't critical as it had to go anyhow, I'm keeping the Lux...
I have a set of the RCI steps arriving soon. 5* angle with tread plate. Looking for how much anyone trimmed from the plastic rocker trim on the front and rear. Currently, I've found 4" on the front and 2.5" on the rear as measured from the top of the plastic. Any advice is welcome. From the...
I currently have a 74 FJ40 with a 2f engine and 75 carb. Can I use the original setup on the 74 which consists of the wire on the harness side coming through the firewall (attached picture) or do I have to use the 1975 setup? Any help would be greatly appreciated. Thanks
The previous owner cut these bumper mounts (which I think are called frame horns?). I was planning to get an aftermarket bumper at some point because this custom bumper that was on it when I bought it doesn’t tick all the boxes for me.
Will this cut cause problems with installation? I’ve been...
I have a 1972 FJ40 body that was rusted in all the normal places. I cut out a lot of the pieces in anticipation of replacing them. A friend with a large brake helped form wheelwell and sides but are very rough.
The cowl, B pillar and the rear top rails are okay. The front footwells are decent...
Done enough research and believe I have isolated my problem to the fuel cut off solenoid….do these work sporadically before failing?
My 2F engine runs fine for days….then occasionally will give me all signs of a malfunction fuel cut off solenoid (will not idle, cuts-out while driving, and will...
I have a '93 FZJ80 with factory wheel arch flares.
I've removed the factory side steps, and the mudflaps have cut outs where the side steps were.
Did any '93 have flares and no sidesteps?
Bonus points if someone can give me a part number for mudflaps with no cut out, if they exist?
Hey all, so recently I’ve been noticing when i accelerate I sometimes will end up going past 10psi and getting fuel cut.
I don’t run a boost T or anything like that, so I shouldn’t be going over the normal stock boost levels.
Im guessing it’s potentially a wastegate issue.
I’m planning on...
Hello all, just wanted to post this up for the benefit of all LC200 owners. I cut open the stock center muffler in hopes that I might get it to flow better. What I saw is quite shocking. It is extremely restrictive, excessive even.