bellhousing

As the title states, I am looking for a BH inspection cover for a FJ40 with a H42 4speed and BH . Thank you

Looking to find the now unavailable FJCO bellhousing to mate a H55F with a 1FZ, shipping to 28461.

I am swapping my 88 FJ62 to manual. It is SOA, so I really need the 85-up bell housing to clock the TC to sit as low as possible. I already have a source for the tranny and TC, but need the bellhousing. Or, if you want to sell me the whole kit in one shot I would consider that as well Located...

Hi, I'm just north of Portland. Need a bell housing for my 73 FJ40 as my current one cracked. Thanks!

Pick up in Glendale, ca. Block needs rebuild. Worn bearings. with oil pan, pump, timing, etc. $70. Just need it out. bellhousing $99, Flywheel $50, clutch and pressure plate in good shape with 3k miles $90(SOLD). and have rear main seal, $40. Email me. Thegreatdakotan@gmail.com. Mark

12HT bellhousing that was attached to an H55 I bought. Includes clutch fork and sensor as shown in the photos. $200 plus shipping.

$500 For sale is as far as I can tell complete 2F motor. Unknown year I was told 1976 Comes with all accessories, emissions look to be intact. Nothing is cut all wires are there. I purchased the motor as a package with a 4 speed I needed. Motor and trans were already pulled when I bought it...

Not sure if anyone has done this before. I've been thinking about this for some time, the early 75-80 bellhousings are harder to find with a good inspection cover. Decided I'd try this and all seems good. the holes need to be drilled and tapped for 12mm bolts. then did the same for the other...

Looking for a good sm420 and adapter plate to 4 speed bellhousing Thanks James 631 873 6912

About three years ago I replaced the front transmission seal in my A440F. The original seal was brittle and fell apart during removal. During a road trip 3 weeks ago, I caught a faint whiff of ATF. Pulled over and found AFT leaking out the bellhousing. I was able to get home but lost about 3...

Still have these used parts for sale for an 80 series manual conversion. H151F to 1FZ bellhousing, clutch, flywheel, clutch fork, throwout bearing, clutch slave cylinder, clutch master cylinder, and clutch pedal assembly. These parts came out of a running driving 1993 80 series Land Cruiser...

I am selling a the 2 part bellhousing needed to mate a 2UZFE to a H151F. The bellhousing is new never run but I did bolt it to the engine and transmission to mock up the motor mounts. I changed the direction of my build so now it is for sale. It will be shipped in the original Toyota...