Hello,
I am currently working on an om606 swap into my fj60 with h55 and need some bj73 parts in order to use the available adapter kit. Here is that Thread. I need the bell housing, clutch fork, and slave cylinder to a euro spec bj73 with the ZM2.5. The bellhousing should be part number...
Hi!
Due to some clever a****** stealing parts from my vehicle while in his possession as a "mechanic", I have been relived of my bellhousing and inspection cover for my 1983 FJ60.
I have some feelers out for an inspection cover and have secured a good bellhousing, but I need the inspection...
First post.
First off, thank you to everyone who has built this into a wealth of knowledge that I've been scouring for two years now. The fact that this is my first post is a testament to how comprehensive this repository is.
I've searched everywhere, and can't find a replacement for the...
Hi folks,
I recently purchased an entire OEM setup to adapt the H151F 5 speed to a UZ series engine. I'm going a different route now with a custom twin disc and am moving these parts along. All parts are new and never installed. Thanks for looking!
2-piece bellhousing
Release bearing
Release...
$350. Will ship on your dime.
I’m all over the SE and can likely deliver between atlanta and Evansville, IN. Birmingham, charlotte, Florida are also frequented. It is getting degreased pre sale.
Thanks Mud.
Selling this very clean bottom inspection/access cover for Toyota foor/five speed bellhousings. I know there are two bolt patterns so check the photos to verify if this is the one you want/need. This one is very clean these are hard to find. $75 buyer pays shipping. Best to email me...
Downey Aluminum universal bellhousing for short-block chevy or BPO (Buick, Pontiac, Oldsmobile). See photos. Obviously it will be removed from the transmission prior to shipment. Seems to be in good condition. $400 prefer local pickup but will ship for shipping cost +$20 for the handling since...
Looking at manual swapping my 94 1kz surf, just wondering is the bolt pattern on an r150 the same as an r151? Will the bellhousing from an r151 bolt onto an r150?
Cheers
Client is going a different direction. Selling off this HJ47 bellhousing, freshly machined flywheel and rebuilt and converted to 12V starter.
This bellhousing bolts to the H series engine (12HT, 2H) and uses the factory mounts on a 40 and 50 series frame to support the transmission. Have...
Client is going a different direction. Selling off this HJ47 bellhousing, freshly machined flywheel and rebuilt and converted to 12V starter.
This bellhousing bolts to the H series engine (12HT, 2H) and uses the factory mounts on a 40 and 50 series frame to support the transmission. Have...